Working with bamboo is difficult. Bamboo is hollow, so probably the only thing you could attach to the bottom of it is a rubber cap. Also, bamboo typically has a slightly oval cross-section, so if you were to make a wooden T-handle for the top with a hole drilled in it, it would be hard to keep it glued on. In addition, even strong bamboo can split longitudinally as it dries, which would reduce the strength. If I were going to make a landpaddle, I'd make it out of wood, maybe starting with an ash shovel or rake handle ($10-15).

I've been doing some research and from what I can tell the bamboo that was used was black bamboo or something of the sort. The guy cut it and dried it himself and then added a bee's wax coating to the outside to add to the strength I'm assuming. I already have a couple of test rigs for a handle and rubber bottom but before I build them I need to see if it's even possible to do without specialized equipment

I didn't want to use a broom handle just because it doesn't flex like a fiberglass or bamboo pole would but if it's going to be a pain to use bamboo then I'll take the easier route and just use a broom handle haha

If you want something with flex, bamboo might work, but my comments above still apply. you have to be very careful with selection and pick just the right diameter so it has the flex you want, but won't break under abuse. Since I'm not a paddleboarder, I can't really advise you on a species. Black bamboo might work, but the bamboo that is most durable and used for construction is Moso.

Ok I have been seeing a lot about Moso on different Web pages. I'll keep doing research and when I get it finished I'll post a picture. Thanks for the help!!

Good luck...