Software
Houzz Logo Print
sail97

Jacking a sagging floor - What will the chimney do?

11 years ago

I have a 1915 house with a bellied, sagging floor. It is obvious in the basement that footings and substantial posts need to be installed. The sag is ~4" all toward the center of the house. There is a brick chimney that runs basement to roof.

Do I need just need to cut the flashing on the chimney before I jack it up? Any cautions or tips you can provide would be great!


Sail

Comments (8)

  • 11 years ago

    Thanks. It appears to only be the first floor. The second floor shows signs of movement but little sagging. I just don't want the chimney to fall to pieces when I start jacking. I can always do a damage assement during the raising process. I have some leads on a structural engineer as I type.

  • 11 years ago
    last modified: 11 years ago

    The chimney should be structurally independent of the floor structure but you must inspect it carefully to be sure.

    You will need a good contractor and an engineer. I suspect you will need to expose much of the chimney so the engineer can see the structure. You should not guess about anything.

  • PRO
    11 years ago
    last modified: 11 years ago

    Jack the sagging floor framing, not the chimney, evenly and gradually, then support the floor framing permanently. Patience and proper framing are the keys. Leave the flashing alone.

  • 10 years ago

    So you are concerned about saving a 100 yr old chimney? Why? What vents into that chimney? It is likely that the chimney is totally deteriorated and needs a total... Inspection first of all. NFPA 211 has an inspection procedure to determine the condition of the chimney. The chimney should be inspected closely prior to doing anything else. You may find it better and cheaper to replace or eliminate the chimney. Once you Jack the place up, if you keep the chimney, if should be carefully inspected again.

  • PRO
    10 years ago

    jackfre:


    Apparently you missed the part of this home being built in 1915. The chimney, used or unused, is a part of the architectural fabric of this historic building and shouldn't be removed or altered without great circumspection.

  • 10 years ago

    Was there any damage when the floor sagged in the first place?

  • 10 years ago

    It is a balloon framed house on a stable field stone foundation. The center wall used in the basement to support the center of the main level is collapsing and not built on a footing. The floors of the house all slope toward the collapsing wall. The joists are still structurally sound. I had a really great older structural engineer out to look at the house and he echoed the comments above. He said, jack the house where the wall collapsed, build a new wall (preferably on a footing) and repair the cracks in the plaster. Done!

    The chimney should not be affected because it is toward one end of the house where there the jacking won't have a significant effect. The chimney IS the primary method of exhaust for the furnace and lined with a 7 inch furnace pipe so the tile integrity should be less of an issue. It appears to be solid at this point so taking it down would be pain.

    Thanks again Sombreuil, JDS and Joseph Corlett, LLC for the information!

    ~ Sail