Software
Houzz Logo Print
fisherff

Square retro fit LED for 8" square cans

9 years ago
Our house was built in the mid 80's. There are 10 square 8" cans in the living dining and kitchen. We are looking for a kit to replace them versus removing and replacing the entire fixture.
Thank you
Square LED 8"x8" Recessed Can Retrofit Kit, 3000K CCT · More Info

Comments (5)

  • PRO
    9 years ago

    Hello, the 8"x8" square is for 5"-6" can housings. We do offer a 12"x12" square fixture that comes with a two-wire connector but not an E26 adapter. The 12"X12" is mounted with a bracket. Perhaps you can use this fixture to cover the opening. Please see the link below:

    https://www.houzz.com/products/pixi-055-thin-1x1-dimmable-flatlight-led-luminaire-2700k-prvw-vr~51036658


    Thank you & regards,

    PIXI Support

  • 9 years ago

    I need one for an 8 1/2" x 8 1/2" square recessed light. Need the light bulb screw in adapter. Pixi, with so many requesting it, can't you make one available???

  • PRO
    9 years ago

    Hi bsslr, We will try to work on it. Even small changes like these require a lot of additional approval by UL who rate safety. Hope to have something soon.

  • 9 years ago

    PiXi, do you know when one might be available ??? And remember the hole is 8 1/2 x 8 1/2. If you just had a frame style piece that could be added to the smaller size and make it work ???

  • PRO
    9 years ago

    Hi Bsslr, those are some good points. We do not have a date yet, but continue to work on developing new products.


Sponsored
High Point Cabinets
Average rating: 5 out of 5 stars21 Reviews
Columbus' Experienced Custom Cabinet Builder | 4x Best of Houzz Winner