Software
Houzz Logo Print
weirdcatlady

Replacing a PRV preventatively?

8 years ago

Last week we received a notice from our town stating that they were going to increase our water pressure to approximately 45 pounds PSI in mid-September . I believe we are currently at something under 30, if memory serves. They are advising that homes be monitored for five days after the pressure increase, and that if your PRV valve is more than 10 years old that you should consider replacing it. Ours is almost 22 years old. We went ahead and schedule replacement for mid July, knowing that if we did not get on the books now, we probably wouldn’t be able to get an appointment. All the plumbers in town are overrun doing inspections and replacements. Is there any question in anyone’s mind that this is a necessary thing? I don’t really understand the PRV valve, but I do know the high water pressure can cause sudden failure in fixtures and pipes. Thanks for any advice.

Comments (4)

  • 8 years ago

    I don't see why you would need a PRV at that pressure. The typical inlet water pressure to a home is about 40 to 45 psi. Normally, it should not exceed 60 psi. The pressure regulator is usually preset to 50 psi.

  • 8 years ago

    Okay, thanks for taking time to respond. That is super helpful to know. Our town must have traditionally had super low water pressure. I do know it is — or always has been — fed to us from massively high towers. We don’t lose water during power outages. They do have scaffolding up on all the towers for some reason.

  • 8 years ago

    If your street pressure is only 45psi, I would consider that low. I have between 60 and 70 in my house AFTER my PRV. I think the street pressure is 100-120psi, but I would have to check.

    PRVs have components in them (filter screens and such) that can require cleaning or replacement over time. Mine failed after approximately 40 years and I put in a new one rather than trying to rebuild it (something you can do with a rebuild kit).

  • 8 years ago

    Thanks very much for that. We had a new plumber here on a small matter yesterday, and he said he could replace our PRV for $150. He took me into the crawl, which is high, dry and clean, and showed me where it was and said it was very accessible and would be an easy job. He also said our kitchen remodeler had put in one waterline prior to the PRV, which he said was a little unwise. He also said that having a PRV in our municipality was required by code (we have incredibly strict and comprehensive building codes in our town) and that our valve looked OK, it had maybe a little more age on it then was optimal. I guess since he does work pretty reasonably and is it independent plumber, we will go ahead and do it, and get that one waterline moved so that it feeds after the PRV rather than before. Thank you all for the education. And it is funny, but I have always thought we had amazing water pressure. But then, I grew up on well water and probably am clueless.