Love your tile. That makes no sense, the cabinets should be the same height

Thanks! The issue is that on the left, it's a 14" cabinet with the microwave below it.

Somebody goofed up the kitchen design. Ca install and other things. Make them correct it. I don’t see any light rail either. Or crown? Why is that light there? Who designed this??

Yes, have the tile end at the same level.

The light is an original from the house that has not been replaced yet. Thanks for your opinion!

Tile it all the way up & put in a recessed light or pendent that matches the one in the reflection. Very pretty backsplash.

I would tile all the way around the window.

joanna i'm fond of tiling all the way around the window too, but in this situation there isnt a lot of room uptop and i think it would look congested.

Just go up around the window. It will be most pleasing to the eye.

Remove cut tile on the right, replace with a whole tile and whatever else you need to make them even.

The cabinets are not level or the window is off so tile all the way or leave the backsplash under the window and really get a new light .

I would have the tile end even or tile all the way up.

Your backsplash tile highlights the lack of symmetry. You can learn to live with it. Or you can remove the tile and replace it with a solid color tile with grout the same color of the tile itself. Good luck.

I don't understand. Your cabinets left and right from the window hang at different height level, i.e. uneven distance from counter, or just the MW cabinet hangs higher?

I would also tile all the way up. Painting a different color will just highlight that area and make the uneven backsplash more noticeable.

ooops. i still see the uneven cabinets, and perhaps even more than in the first photo.

The cabinets are all the same height from the ceiling. The microwave and cabinet on the left side are slightly higher (more distance from the counter/stove) than the cabinet on the right.

I'm not really worried about making the cabinets look like they're the same. It was the uneven tile that was looking bad. I like the idea of tiling mid-way up the window so that the tile ends evenly.

Thank you everyone!

I would camouflage the problem by installing a paper roll on the side that is higher ...or a shelve ...just so that the visual problem is gone instantly .

Just leave it or go somewhere else for a little advice.

Tile all the way up as numerous people have suggested and as Emily has so kindly pictured. Doing so turns this awkward detail into a beautiful feature. The small scale of the tile makes it an especially wise choice to take all the way up.

Get the taller cabinet for over the MW shelf as should have been ordered from the beginning. Then the heights will match.

The next taller cabinet for over the microwave is 18". It would not make the heights match. Thank you, though!

I would tile the whole wall all the way to the ceiling, but before you make that decision, verify that the ceiling is level/horizontal. If it is not completely horizontal at the ceiling, then just take the tile up about halfway up the window on both sides.