Software
Houzz Logo Print
iamronnisa

Installers issue

8 years ago

This story is too long to type out but basically, I have installers coming back to make adjustments on my quartz tops. They shorted the length of one backsplash and installed it anyway, forgot to bring another backsplash, told me to get the wrong size sink and then poorly installed it ( jammed it in, no room for clips, didn't shim it and now it's separated from the counter at points.)

They have argued with me all the way and are coming back today to install backsplashes, remove excess epoxy on my cabs and "fix" the sink. I'm not sure how they're going to fix the sink considering they mucked it up so bad the first time. I don't trust any of it was done well.

Would you ask them to remove the sink, install the backsplash and pay someone else to come and install the sink safely? I've even got a sink replacement b/c they had scratched up the one I had and told me to buy a new one, then retracted the offer b/c they decided it was my fault. I just want them to be done and get out at this point- thoughts?

Comments (9)

  • PRO
    8 years ago

    So for starters you choose your sink and the fabricators make the counter work with it they do not tell you what sink to buy. I would be talking to the owner of the company not the installers.

  • 8 years ago
    And this is why the Pros who so wonderfully give advice on this site should not be surprised when consumers comment they have no trust. Don't pay them until it's right.
  • 8 years ago

    This is something Joseph Corlett should look at.

  • PRO
    8 years ago
    last modified: 8 years ago

    When I first entered this industry 35 years ago....someone picked out a topmount sink and it just fit. There was very little to think about. One of the problems today is that undermount sinks require more wiggle room and they require more planning and checking and sometimes modifications due to clearance issues. People today want large sinks and they want them undermounted. Fitting faucets at the back is now an "issue" and never was years ago. This is due to an undermount popularity, tile backsplash and large big sink combo platter! From the photos: your sink seems to fit your sink base fine (width-wise). So I would reuse that sink...just get them to attach it better. Get Joe to advise on that.

  • PRO
    8 years ago

    The rear clips were in the way of the faucet holes, so you just eliminate them? Anytime I see an adhered wood shim bridging the sink flange and stone bottom I immediately think of Jed Clampett from the Beverly Hillbillies sitcom of years ago. These guys are clueless hacks and you can tell them I said so.

    Drop the sink, abandon the clips completely and strap the sink in place with a Hercules Universal Sink Harness (Braxton Bragg) or a Sink Strap or two from Regent Stone Products, please.


  • PRO
    8 years ago
    last modified: 8 years ago

    If you are planning to tile, skip the quartz back/side splashes entirely please. Focus on the sink, sink straps, and silicone.

  • 8 years ago

    Thank you all so much. They came and removed the sink, cleaned both surfaces and re installed. They added more clips on one side by notching into the cabinet beside it. I asked them to clamp for me but they didn’t because they refused to think anything could happen. I shoved whatever i could

    nderneath it and will get a reinforcement system in place as suggested.

  • PRO
    8 years ago

    There is no exposed silicone in the gap between your sink and top. That means the gap is going to be filled with crud. I don't like this installation, but since yours is a single bowl sink, the end clips may hold it in place just fine if they've eliminated the glued wood shim.