Software
Houzz Logo Print
kathyg_in_mi

Have Dirt Devil Flipout hand vacuum

8 years ago

Battery died and company said to return battery to company to replace the vacuum, it is still under warranty. Trying to save myself some postage and trying to take out the battery to send just that. Can't figure out how to open unit. All screws are out.

Will call Dirt Devil tomorrow to get some help, but trying here first.

Checked YouTube, nothing on it.

Thanks, Kathy G in MI

Comments (12)

  • 8 years ago

    If you look at the owner's manual (available online) it gives very specific instructions to NOT try to remove the battery.

    kathyg_in_mi thanked Olychick
  • 8 years ago

    I have the owners manual that came with the vacuum. Says nothing about battery! Will check it out on line. Thank you.

  • 8 years ago
    last modified: 8 years ago

    Read owners manual and it says to recycle battery. Can’t do that or send in to company unless I get it out of vacuum.

    Can’t wait to hear what Dirt Devil has to say.

    This is what I’m trying to take apart, rather DH is!

  • 8 years ago

    This is what I saw in the owner's manual, maybe it means something other than removing battery:


    https://www.manualslib.com/manual/1232060/Dirt-Devil-Flipout.html?page=5#manual

    On another note, how do you like the vacuum?

    kathyg_in_mi thanked Olychick
  • 8 years ago

    Call them again and ask nicely until somebody agrees to issue a call tag. Then you don't have to pay for shipping and the problem is moot

    kathyg_in_mi thanked M
  • 8 years ago
    last modified: 8 years ago

    It means do not try to see what is inside the battery not do not removed the battery. I do not know how heavy the battery is but it probably will not add much weight to the package.


    Edited to add: The whole handle portion is the battery so Olychick is right you should not attempt to open any compartment on the handle because that would be opening the battery. At least that is how I am reading the manual because you are charging the handle portion which should mean that is the battery.

    kathyg_in_mi thanked User
  • 8 years ago

    A 20V battery pack probably has 7 of 3V lithium cells wrapped together. I read that warning as do not take the battery pack apart - Good advice. Also, be careful when handling the pack. If a cell or cells has leaked, there could be corrosive gunk/liquid present. If any has leaked to the outside of the package, it could get on your hands and chemically burn.

    Can't get it apart - most likely, you have not found all of the screws. From what I've read about other Dirt Devil hand vacs, you do not have to take the vacuum apart. The battery pack on those is under a plate held by a Phillips screw. This plate may be on the bottom. However, your unit does appear different. Apparently, the housing is 2 half shells.

    From the picture you posted, I see recesses for 4 screws. There could be more. Once you get inside, the battery leads may be soldered to other leads. If so, do not cut! Use a soldering gun/iron to disconnect. If you are lucky, the leads are connected using standard wiring nuts. If soldering and wire nuts are unfamiliar to you, your best bet is to do what the manufacturer recommends and that is to ship the entire unit back for service. That will save you a lot of unnecessary work and you might abort the warranty by taking it apart. You won't be saving much in postage by removing the battery. It may weigh as much as half of the entire assembly.

    Weigh the cost of repair versus a new one. If the cost of repair is 1/3 the price of a new one, maybe replacing it is the better option.

    kathyg_in_mi thanked jemdandy
  • 8 years ago

    Ding, ding, ding! We have a winner. maifleur01 & Olychick

    I called this morning and they told me to send back the handle unit!

    Also reread the directions on the email they sent and it says that I have to pay for shipping to them, no call tag, M.

    Since the vacuum cost me $50 and they are going to send me a new one, it should be worth paying for the postage to send it back. Now to look for a box!

    Thanks for all the support everyone. Will report back on my mailing cost.

    BTW, I really liked it a lot, but never used the extra tools it came with.

    When it stopped working, I went out and bought a cheaper one right away! I do like my hand vacs.

  • 8 years ago

    If it'll fit in the USPS flat rate priority box I think it will, it was $15 for me to use a week ago.

    kathyg_in_mi thanked rob333 (zone 7b)
  • 8 years ago

    Walmart. Warranty is up in October.

    Good idea to check priority box size.

    Will let you guys know What happens.

    Wish I would have tried to return to Walmart first!

  • 8 years ago

    Ding, ding, ding! We have another winner. Rob 333’s idea of the priority box is right on! Picked up one today and it fits! Will cost me $13.75 to mail.

    i love THS KT. I all ways get great advice.

    Thanks all!

Sponsored
High Point Cabinets
Average rating: 5 out of 5 stars21 Reviews
Columbus' Experienced Custom Cabinet Builder | 4x Best of Houzz Winner