Software
Houzz Logo Print
maddy_burke

Potted Dwarf Meyer Lemon Watering

7 years ago

Long time reader first time poster... Thanks everyone who is active here for all of the great information on growing citrus and on potting physics! I have a soil meter and am unsure if I am supposed to water when the top drainage zone is dry or if I should wait until the PWT dries out as well?


Context: I am worried about overwatering my 3year old 4' meyer lemon; I know they are very susceptible to root rot but I also assume that it takes a lot of water to make lemons. My tree went through a huge new growth phase and flowered profusely (I fertilized). But now I have some yellowing in lower leaves and about 30% blossom drop (maybe that's normal, maybe I am overwatering, or maybe it was just too cold still the day I took it outside...?).

Comments (4)

  • PRO
    7 years ago

    Or maybe too much fertizer. I would take it to a garden center and see what the experts say.

    Maddy Burke thanked Patricia Colwell Consulting
  • 7 years ago

    Hi, Maddy ...... and welcome. Try this experiment with your water meter: Pour a bit of water into a clean cup. Clean the tip of the meter's probe ans put it in the water and note that it reads 'DRY'. Now add a pinch of salt or baking soda and watch the meter go all the way over to wet. It reads electrical conductivity, not moisture; and, what's most important is how wet/moist the bottom few inches of soil is. The roots at the top of the soil function more as conduits (plumbing) to move water/nutrients up to the top of the plant through xylem tissues, and photosynthate/bio-compounds downward to finer and newly formed roots, while the fine roots deeper in the pot do the lion's share of the heavy lifting for the plant.

    Using a 'tell' made from a wooden dowel rod works very reliably to 'tell' you what moisture levels are where it most counts. I hope what I wrote about using a 'tell' helps:

    Using a 'tell'

    Over-watering saps vitality and is one of the most
    common plant assassins, so learning to avoid it is worth the small
    effort. Plants make and store their own energy source –
    photosynthate - (sugar/glucose). Functioning roots need energy to
    drive their metabolic processes, and in order to get it, they use
    oxygen to burn (oxidize) their food. From this, we can see that
    terrestrial plants need air (oxygen) in the soil to drive root
    function. Many off-the-shelf soils hold too much water and not enough
    air to support good root health, which is a prerequisite to a healthy
    plant. Watering in small sips leads to a build-up of dissolved solids
    (salts) in the soil, which limits a plant's ability to absorb water –
    so watering in sips simply moves us to the other horn of a dilemma.
    It creates another problem that requires resolution. Better, would be
    to simply adopt a soil that drains well enough to allow watering to
    beyond the saturation point, so we're flushing the soil of
    accumulating dissolved solids whenever we water; this, w/o the plant
    being forced to pay a tax in the form of reduced vitality, due to
    prolong periods of soil saturation. Sometimes, though, that's not a
    course we can immediately steer, which makes controlling how often we
    water a very important factor.

    In many cases, we can judge whether or not a
    planting needs watering by hefting the pot. This is especially true
    if the pot is made from light material, like plastic, but doesn't
    work (as) well when the pot is made from heavier material, like clay,
    or when the size/weight of the pot precludes grabbing it with one
    hand to judge its weight and gauge the need for water.

    Fingers stuck an inch or two into the soil work ok
    for shallow pots, but not for deep pots. Deep pots might have 3 or
    more inches of soil that feels totally dry, while the lower several
    inches of the soil is 100% saturated. Obviously, the lack of oxygen
    in the root zone situation can wreak havoc with root health and
    cause the loss of a very notable measure of your plant's potential.
    Inexpensive watering meters don't even measure moisture levels, they
    measure electrical conductivity. Clean the tip and insert it into a
    cup of distilled water and witness the fact it reads 'DRY'.

    One of the most reliable methods of checking a
    planting's need for water is using a 'tell'. You can use a bamboo
    skewer in a pinch, but a wooden dowel rod of about 5/16” (75-85mm)
    would work better. They usually come 48” (120cm) long and can
    usually be cut in half and serve as a pair. Sharpen all 4 ends in a
    pencil sharpener and slightly blunt the tip so it's about the
    diameter of the head on a straight pin. Push the wooden tell deep
    into the soil. Don't worry, it won't harm the root system. If the
    plant is quite root-bound, you might need to try several places until
    you find one where you can push it all the way to the pot's bottom.
    Leave it a few seconds, then withdraw it and inspect the tip for
    moisture. For most plantings, withhold water until the tell comes out
    dry or nearly so. If you see signs of wilting, adjust the interval
    between waterings so drought stress isn't a recurring issue.

    Al

    Maddy Burke thanked tapla (mid-Michigan, USDA z5b-6a)
  • 7 years ago

    I had problems w/ yelllow leaves on a lemon and it was a nutrient problem. I agree with the suggestion to ask your local good nursery. Or google: citrus yellow leaves. Lots of info. More than I can post. Good luck!

    Maddy Burke thanked girl_wonder
  • 7 years ago

    wow, guys, thank you so much! Tapla I am definitely going out to get some dowels asap <3