Software
Houzz Logo Print
homeluv2018

sagging joist fix - please help!

7 years ago
last modified: 5 years ago

Hello- I had a sagging joist and hired a contractor to fix. I don’t have any experience with this stuff but wondering if this fix is sufficient.

Thanks for your help!




Comments (4)

  • 7 years ago

    Sorry, sagging header!

  • 7 years ago
    last modified: 7 years ago

    That appears to be a girder/beam, not a header. Who did the work? Details, please. You might want to do a little light reading here since it appears your home was built using wooden structural members only, as opposed to a mix of steel and wood. What does the stamp on the wood say? I’m assuming it’s SYP (Southern Yellow Pine) PT (pressure treated) wood. How is the top horizontal member attached to the two vertical pieces? How are the two vertical pieces attached to the bottom horizontal member? I can see the bolts used to secure the bottom piece to the top of the foundation wall.

    To answer your question, though, the repair seems okay; not perfect, but okay. I don't think the house above is going to be falling down anytime soon.

  • 7 years ago

    Actually, the more I look at it, the more questions I have and the less “okay” I feel about it. For example, was that part of the foundation wall always missing or was it recently removed to gain access to that crawl space? Is that wood girder/beam structurally sound? It looks like it has suffered some moisture damage. How is the new support tied into the old/existing support pieces on either side of the opening? Are the vertical pieces of the support attached to the vertical openings in the foundation? Hopefully a professional with expertise in this area will weigh in.

  • 7 years ago

    Sammy, it looks like the vertical pieces are toenailed to the horizontal ones.


    Looks like a quick, dirty & cheap fix that is just OK. At the very least, I would prefer to see a clean 90 degree cut on the old beam with a tight friction fit between the old and new. And some steel mending plates (both sides, front and back) to tie the new splice into the old beam and the new vertical supports.


    Preferred fix would involve quite a lot more work. As in getting those plywood structures (shelving?) out of the way and splicing in a new plate that spans the opening and goes back under at least one of the other floor joists on both sides. Sistered 2 bys on edge w/ stagged let-ins on the old plate, glued & screwed. Tight fit w/ steel mending plates/ strapping. With vertical support at the crawl space opening...where you could have used a single 2x on either side and preserved more of the opening.


    More work in tight quarters and need temporary supports for the joists while fitting in the new repair. $$ Not a fun job.