Software
Houzz Logo Print
weston_clark

damage caused by rubbing tab pulls/finger pulls.

6 years ago

I'm trying to find out if anyone else has had experience with stopping or slowing damaged caused by finger pulls, tab pulls, or edge pulls. Not exactly sure what they're called. We just installed a new kitchen and knew that these were a little thick but had enough space in theory if nothing moved. But we didn't really calculate in the weighing down of the drawers once we put stuff in them. now they seem to be rubbing the bottom of the drawer with the top of the edge pulls.

I'm less concerned with the damage to the hardware itself. We have extra and can replace them when they get bad. I'm more concerned about it tearing apart the bottom of the drawer. One solution we thought of as a possible clear coat or plastic coating that's super thin, obviously, like a protective covering for a phone. But, of course, don't have any idea where to get something like that..

Anyone else experience anything like this? come up with a solution?

Comments (12)

  • 6 years ago
    last modified: 6 years ago

    You need to route out the area under the pull so that the pull sits flush with the top edge of each drawer. That is the proper way to do it, unless you had the cabinets custom made to allow for the extra thickness between drawers.

    Weston Clark thanked chispa
  • 6 years ago

    yeah, in retrospect that is the right thing to do. it was suggested but at the time we didn't know how thick our handles were going to be. any idea how hard it is to route them after the fact?

  • 6 years ago

    I had to do the same thing with some cabinet doors, although the cabinet was custom made and I had given the cabinet maker the dimensions of the pulls, he still didn't leave enough room!

    A good finish carpenter can do it easily. You just need someone who takes pride in their work and knows how to measure twice and cut one!

    My doors stayed without pulls for a while until I had a GC in the house doing some other work and I asked him to install the recessed pulls. It didn't take him long at all.

    Weston Clark thanked chispa
  • 6 years ago

    thank you. I think we may pursue this direction.

  • 6 years ago
    last modified: 6 years ago

    I'm no help, but can commiserate as I have 25 of those exact same pulls sitting in my basement because we ran into the same problem. I'm going to use them for the upper cabs, but find something else to coordinate for the lowers.

    Weston Clark thanked daisychain Zn3b
  • 6 years ago

    @kudzu9 thanks for bringing that up. it had crossed my mind. I think the technical term we are at is "screwed."

    I'm a little angry at the cabinet place for not alerting us to all these problems. we hadn't showed them the exact pulls but had told them we were planning on edge pulls. didn't realize they would cause so much trouble.

  • 6 years ago

    @daisychain01 maybe we get together and have a edge pull bonfire?

  • 4 years ago

    My wife wants edge pulls on everything. I went an bought 1 edge pull today to check it for fit on all the different doors and drawers. I see this exact same issue with not having enough space between the drawers! I'm going to go with edge pulls on the upper doors (no issue there), and typical pulls on the lowers. I also found that the smaller edge pulls don't have much surface to grab, so its difficult to pull out drawers with Blum closers.

  • 3 years ago

    When it comes to redrilling the holes, barely down, here’s what I did. Fill the original handle holes with wood filler or epoxy. You have to do a clean job

    Next, use a self centering bit so that the handle is mounted perfectly.

  • 3 years ago

    Another idea. Some drawer mounts / hardware is adjustable.

    I am going to try to move the drawer down that way first.

  • 3 years ago

    I got the bit at Lowe’s. It’s the #6 model