Software
Houzz Logo Print
webuser_404771960

Which faucet should I pick?

5 years ago

Hello,
We are remodeling our kitchen and I’m not sure what faucet to get. Originally I thought we would go with polished nickel to make the kitchen look warmer but now I’m worried that’ll be a mistake. All our appliances are stainless steel except for the flush mount ceiling hood which is white. It is difficult to tell in the photo with all the shadowing but our cabinets are white (technically KM Swiss Coffee), our pulls are Top Knobs Ash Grey, our sink is a Cinder Blanco sink, our counter top is white with a small amount of grey/blue, our island is grey with blue tones and our walls are to be tiled with Metro Grey (which looks like a warm white to me). Our flooring will be a lighter wood color LVP. I’m wondering if I should pick a faucet that is dark like the sink and pulls to contrast all the white or if I should go with stainless steel to match our appliances? Any suggestions are appreciated!!

Comments (10)

  • 5 years ago
    last modified: 5 years ago

    is the faucet to be offset on the right/ is left better? sink drain apparently on right? window is right down to counter ...lots of light/ fingerprints show.......you want minimal splashing and seal up w caulk nicely along there. Configuration is more important than finish here. I think the dark finishes are dull and matte and dont show finger prints if Im not mistaken. Maybe go that route. This is one instance I might not pick really hi arc faucet and if you can sneak it forward away from window even an inch or two without being terribly atypical I'd feel more comfortable. I'm sure there's a reason bottom of window is right down there but exercise care. The right side of window is moveable side??? it looks so....trying to calculate what you can do w placement to avoid splashing in other words but the right counter is your longer and near fridge.....you could make case for faucet on left away from moveable window/away from wider counter run near fridge....but the drain of sink ? it is not centered ... not certain about how everything lines up. All I know when it comes to seals and wear and tear you dont want water issues w window framing . How do you look upon this?

  • 5 years ago

    @herbflavor Thank you for your reply. I hadn't thought of offsetting the faucet. I worry it will look even more asymmetric if I don't put it down the middle. I originally wanted a centered drain but then liked the idea of the extra space in the cabinet under the sink and also assumed it wouldn't be obvious that the drain is to the right unless you looked from above the sink since it is deep. Thanks for noting that fingerprints will show with all the light from the window, that's a good point. Yes, we realize the height of the window being flush with the counter top/sink is an issue. The original builders did that and unfortunately our contractor made it sound as if it would cost us way more to move it up (and there are other 3 other windows in the kitchen also at the same height so we would be having to actually redo and move up a total of 4 windows. Conversion to a bay window was an after thought but it is too late since the contractor has already received the new window he is installing. Yes, the window over the sink opens from the right. I'm wondering if I can do a black stainless steel since in pictures the color seems close to the Ash Grey pulls and Cinder sink, but my appliances are just plain stainless steel. I worry a black matte faucet will be too dark compared to our pulls/sink. Our contractor had originally suggested a Delta Artic Stainless faucet with electronic touch. I guess it is a brushed stainless so fingerprints are less likely to show up and the touch feature allows us to touch the body or handle to turn on and off (maybe that will help with splash). Thank you!

  • 5 years ago
    last modified: 5 years ago

    Do not offset the faucet. It will look odd as you suspect. Tons of people have a sink with an offset drain (including me) because it is a big advantage for the functionality of the sink. They don’t offset the faucet. The faucet should be centered.

    The splashing argument doesn’t make sense. If there will be splashing from the faucet (and with the depth of your sink, it will be unlikely to splash outside of the sink), the splashing will occur whether the faucet is centered or it is offset. I don’t even understand how offset placement would somehow avoid splashing, What position would you place the faucet to do that? Offset to the right? It would overshoot the drain. Offset to the left? It would be too far from the drain. Regardless of placement, a faucet swivels as part of its functionality to make the water go where it is needed, so there will be times it is over the drain and times when it isn’t.

    Also, will you have any other fixtures at the sink such as an disposal air switch, soap dispenser, hot water dispenser? Where do you place those if you’ve offset the faucet?

    In response to your original question about a polished nickel finish, I would not choose polished nickel for a kitchen faucet. It is higher maintenance than polished chrome or a stainless steel finish. Polished nickel will tarnish over time, and need polishing. I have polished nickel faucets in my bathroom, and they came with a protective finish which wore off after a couple years, so now the faucets tarnish. In a kitchen, faucets get much heavier use than a bathroom. Unfortunately, a stainless steel finish in a faucet is costly. If you don’t want to spend that, I recommend polished chrome. While it will show fingerprints, they are easily wiped with one swipe, and a polished chrome finish will stay gleaming forever.

    Edited to add: I do agree that your pic makes it seem you won’t have enough depth front-to-back for both the sink and the faucet behind it. It could just be the pic. What is the depth from the counter edge to the window? It may be that an apron front sink could give you an inch or so to fit the faucet, or alternatively you’ll have to bump out the sink base cabinet.

  • 5 years ago

    I agree to keep the faucet centered. Don't do a dark finish on the faucet.

  • 5 years ago
    last modified: 5 years ago

    Why when I clean down my sink/ faucet / and backsplash there is a bit of food splash/ water and water marks around base of faucet / in the crevice between counter and backsplash particularly near faucet and on the splash. That’s why it’s called backsplash isn’t it? nothing that regular attention and a sponge doesn’t clean . So you seriously think keep the faucet in the rear right in middle where two panes of glass meet and corners of window frame sit??? i would absolutely offset that faucet.. good luck.

  • 5 years ago

    Thank you @Shannon_WI. The cabinets below the sink are 24" The window sits back an additional ~4-5" (I guess it would be considered a "sill" but our countertop is going to extend in that space).

    Thank you all for your suggestions. I am going to likely go with Stainless steel unless I change my mind again. I was considering black stainless steel since that is closer to the color of my pulls/sink but I'll probably go with just brushed stainless.

  • 5 years ago

    I would not offset the faucet. Two reasons:

    1. Faucets swivel. You want the faucet to swivel over the sink and to not be able to swivel over the countertop. And, no, it does not have to be kids who will do that.
    2. A centered faucet will allow two people access to water at the sink. If offset, only one person can use the faucet.

    Polished chrome never goes out of style. And it is easy to clean. Usually costs less than the other finishes. Every other finish is trendy AFAIC.


  • 5 years ago

    not much help on the faucet suggestion (ours is polished chrome I believe with a stainless sink)- but we are getting new hardware and looking at the Top Knob Ash Gray because we have black stainless appliances and my husband isn't sure about brushed gold (which I was leaning towards). Which pulls did you go with? Would the go with Black Stainless? (my cabinets are also swiss coffee with concrete looking counters)

  • 5 years ago

    @thompsoc75, we got the Top Knob Ash Grey. That is what is we have installed on the Swiss coffee cabinets in the first picture but it is hard to tell with the shadowing. I personally really like the Ash Grey with our kitchen. Seems to give it some contrast since we have a lot of white. We opted for a regular stainless steel faucet. The black stainless faucet was definitely darker than our ash Grey pulls. The closest color faucet I found to the ash Grey was Brizo’s Luxe steel and I almost went with them but they don’t make air switches and the other brands that I tried to match weren’t as close as I’d like. So ultimately stuck with good ole stainless steel (our appliances are plain stainless steel). Hope that helps a little.

  • PRO
    5 years ago
    last modified: 5 years ago

    I would personally suggest matte black in your case! Or, a mixed metal finish faucet (stainless and matte black or chrome and matte black)

    Will you be doing any pendant lighting? If so what finish will this be in?