Software
Houzz Logo Print
joanneh311

How to remove a small amount from a wall tile

5 years ago
last modified: 5 years ago

I just replaced some switches and an outlet in a 3 gang box in my kitchen with more attractive rocker switches. Problem is that the switch housings are wider than the old ones, and the receptable on the left and switch on the right are bumping up against the wall tile. This is making it difficult to get the cover on all three switches as once as one of them is always off from the screw holes. Is there an easy way to shave down the wall tile edge a bit to make them fit? Will a tile file work? thanks.

Comments (12)

  • 5 years ago

    Thanks, I have a dremel tool just have to find the right attachment.

  • 5 years ago

    I ran into the same problem when I replaced my backsplash with a granite sheet. Instead of altering the edge if the granite we decided to trim the switch cover a bit to make it fit. But the switch cover was not very decorative so I don't know if this is a good option for you

    Joanne thanked FREDA HICKS
  • 5 years ago

    I’ve ordered a bit for the dremel, if that doesn’t work out I’ll probably have to trim the cover a little. It’s only off by a very small amount.

  • 5 years ago

    I successfully did something like this with a Dremel tool after our last bathroom remodel. I will only caution that you need to be ultra careful as it can be slow going with really hard porcelain tile, and it is easy when you are applying pressure to slip a little and have the business end of the tool pop out of the hole and skate across the surrounding tile. This is not a result you want.

    Joanne thanked kudzu9
  • 5 years ago

    Is there enough space on the wall to have an electrician move the outlet/switch to another area to avoid cutting the tile?

  • 5 years ago

    Not without cutting the tile in another spot to install it.


  • 5 years ago

    Depending on the tile, you can probably use one of the sanding drums in your dremel kit. What's a "little bit", 1/16, 1/8. 1/4? I've also used a multi tool with the sanding attachment to "trim" tile 1/16-1/8".

  • 5 years ago

    Based on my own experience, I doubt a sanding drum would last long enough. I went through two solid silicon carbide drums to remove material that was somewhat blocking the screw holes on the electric box. It will depend on the hardness of the tile. A drum shape, rather than a wheel shape, is easier to control and helps you stay inside the tile perimeter without marring the surrounding tile area.

  • 5 years ago

    Doesn't sound like you have much experience...

  • 5 years ago

    You're right, I've only been doing home renovation for 45 years. Always good to hear from someone who can be confident without knowing the details...

  • 5 years ago

    Thanks for the picture. They help when making comments. Let us know how things turn out.