Software
Houzz Logo Print
webuser_741289418

Shaker drawer front installation feedback

4 years ago

There are so many things that are not so great about our ongoing kitchen project. Here's how our contractor handled the cabinets. Looking for feedback about the reasonableness/unreasonableness of our requests to remedy.


Here's a link to our countertop issues (yet to be resolved) for the curious: https://www.houzz.com/discussions/6211934/are-my-soapstone-countertop-expectations-unreasonable


My main query for feedback/input is regarding the nature of installation, but I'll share one of many other issues in case it helps:

  • used old drawer boxes & glides, though billed for nearly $1000 for these (plus whatever labor that wasn't performed)
  • No pilot holes drilled for wood screws resulted in some splitting in the dovetails (somewhat of a non-issue at this point because they have to actually get and install the boxes we're paying for, but does this method of cranking standard wood screws in the corners look right?)


We have shaker-style fronts. Naturally these are recessed on the front. They are also recessed on the back. Typical install looks like this (and this one is the least objectionable:




There is a quite noticeable warping in the drawer front where the handles were just cranked down into the recessed back.


This gets worse on different drawers, largely I suspect because the incorrect fronts (oversized) were ordered and just installed anyway:




You can see above that the box is affixed to the thicker edge on one side and not at all on the other where it lays on the recessed edge.


You can see this even better in the following composite picture of 2 ends of the same large drawer:




With those wood screws inserted two in the side and one in the bottom.


The large drawers were the wrong size, so on one side there is 1.75' of front (left in pic), and on the other side about 3" (right in pic). I presume this is shoddy installation of the incorrect size drawer. See top view of offset here:




We have a single identical drawer elsewhere that I replaced these with to demonstrate the correct width of these cabinet fronts. See below:




Attempts were made to just do the work even though it had to be pretty clear to the installer that something was off. See below:




All of these issues add up to all of the drawers also not laying flush to the cabinets throughout. However, this is most pronounced on the shoddiest work on the oversized drawers, seen below:




Maybe not super easy to discern in photos, but the bottoms are about a full 1/4" further out than the tops.


So, my questions:

  • These are basically unacceptable, shoddy work, right?
  • How should the recessed backs be properly dealt with? Would correct birch box size help?
  • Drawer fronts shouldn't be warped to shape to install handles, right?
  • Should pilot holes be used on the new boxes to prevent splitting?
  • What about those standard wood screws, which in several cases aren't even close to being screwed in completely leaving the head exposed in the front of the drawer. Also not ideal, right?

Thanks for reading and feedback.


Comments (6)