Software
Houzz Logo Print
demetri_kouloheras

Replacing mailbox on granite post

My mailbox was secured to a granite post via a couple very rusted threaded rods that were epoxied into the granite post. The nuts holding the mailbox bracket on the threaded rods were also very rusted and after a PB Blaster soak and a few gentle raps of a hammer were still stuck solid to the rod. I ended up torquing them off and the threaded rod sheared. So now I figured I'd drill out the threaded rod from the granite with a cobalt drill bit, epoxy a new threaded rod in the old hole I drilled out and be done with it. Thing is that drilling out the old threaded rod has proven itself to be much harder than I expected...I hoped the metal would prove much softer than the granite and keeping the bit centered would be easy, but is not at all. After about a half hour of labor I'm only chewed up a quarter inch or so of the old threaded rod. The cobalt bit tip still feels very sharp. What should I do? I'm contemplating filling the old holes so water can't get it and just drilling another couple holes with a masonry bit. What's the easiest way to do this? Photos below of old black mailbox, the post with the bracket removed and threaded rod partly drilled out, and what will be eventually taking the place of the old mailbox.




..Right now I have my new mailbox strapped into position so I can still get mail..