Software
Houzz Logo Print
li92

Which peninsula? Open, boxed, table leg?

3 years ago

I have a peninsula (40"wide x 88" long) that was designed with standard 24" base cabs on one side and 12" deep base cabs on the other side, with 45" between the shallow bases and a decorative end panel on the exposed side:



I decided after ordering that I'd like to move the right hand base cab over to the left and have the exposed area on the right instead of the middle, like this:




In all cases the overhang is supported by steel brackets so there is no structural concern. My question is, if I move the cabinets over, how should I handle the exposed end? I could re-use the 3/4 thick decorative end panel I already have (but would it look flimsy?), or order a new shorter end panel (25.5" instead of my current 34.5"). With a new shorter end panel I could either leave the overhang entirely exposed or put a table leg at the corner. Which of these would be best?


full end panel
short end panel
short end panel and table leg

Comments (5)