Probably $200-300 bucks, location dependent.

I'd charge a neighbor at least a six pak plus $5 to cover Sil-Fos. For kin folks and strangers I'd undercut Millman and do it for $199-299 bucks.

Hi, I think the burning question is Why would you need a drill to change the angle stops.

Good Luck Woodbutcher

HI, Sorry, I did not read you put the hole in with your puller.

Good Luck Woodbutcher

Of course, since we already know you are handy, you could learn to sweat copper. Buy a torch, some flux, solder and cleaning tools. Then practice on some fittings that you buy just for that purpose.

I'm sure that there are plenty of videos on YouTube to show you how to do it.

Just make sure the water is out of the pipe well below where you are trying to solder.

Or Flex Seal? (;