Software
Houzz Logo Print
mookie31973

Window Treatment Dilemma

6 days ago

Hi, I would really like to do a sewing project and have inside mount roman shades for this room. There are reasons why I can't do curtains as this is a guest bedroom and twin beds will obstruct where curtains would be hung. My issue is that I have the depth to install inside mount roman shades but there are these projections (chatGPT says they are "sash balance mechanisms") that would require me to cut down on the width of those shades. I don't really want to do outside mount because I think the frames of the window are really pretty. Open to any thoughts or insight.





Comments (8)

  • 6 days ago

    the bracket for the inside mount blinds I have are attached to the upper framework, not the sides... look at the shade and find a source that suits YOUR window.

    Molly thanked Lyn Nielson
  • PRO
    6 days ago

    those sash balance covers usually sit in the jamb pocket, so you can still do inside mount if you mount the headrail to the top of the frame and just make the shade about 1/4" narrower than the space between the projections each side. a small light gap is normal with roman shades anyway. add a blackout lining and nobody notices, and you keep that pretty trim showing.

    Molly thanked Boss Design Center
  • 4 days ago

    Like Boss Design said - why can’t the shades be mounted on this surface?



  • 4 days ago

    Inside mount roman shades will not work esp if you want light blocking. When shades are drawn up the trim will still be visible. I have light blocking on all bedroom windows and worth the expense. The store I ordered from sent their people out to measure for accuracy. Also if you live in a cold winter climate condensation can build up when shades are down.

  • PRO
    4 days ago

    Inside mount shades would not fit properly on your windows. The recess is much too shallow/small, unless you wanted the shades to protrude from the frame. That would look weird and there'd be a space where light can come through when the shades were down.

  • 3 days ago

    I have a bunch of inside mount Roman shades, If the issue is the two locking mechanisms in the middle of the window, these shouldn't be a problem, if they don't protude beyond the window frame, which is looks like they don't. They may protrude when not in the locked position, but you're not going to have the windows open and your locks unlocked while your shades are down. Or, at any rate, choosing to have your locks locked whenever the shades are down is not a big issue.


    A homemade Roman shade can take up very little space with an inside mount. It's the standard shades you buy where you might have a problem.


    If this is the first time you are making the shades, you want your eye hooks for the cords to be exactly over the cord-guiding loops and to think about which side of the window is most convenient for the cords you pull.

  • PRO
    3 days ago

    @littlebug Zone 5 Missouri got it. If the sides are the problem, mount the headrail to the head jamb at the top instead of the side jambs, since most inside-mount shades only need a flat top surface. Measure the clear width at the tightest point, top, middle and bottom, and order to that number. Then check the shade's minimum mounting depth against your window depth before you order.