Search results for "Flashing" in Home Design Ideas

The National Register of Historic Places plaque on the Gardner Carpenter House - another Historic Restoration Project in Norwichtown, CT. Built in 1793, the original house (there have been some additions put on in back) needed a new roof - we specified and installed western red cedar. After removing the existing roof, we laid down an Ice & Water Shield underlayment. We flashed all chimney protrusions with 24 gauge red copper flashing and installed a red copper cleansing strip just below the ridge cap on both sides of the roof. We topped this job off with a cedar shingle ridge cap.
Find the right local pro for your project

D-Trac Construction was contracted to address install issues from a previous contractor related to the workmanship and install of the exterior hardie board package. Because of the issues, the local county would not pass building permit inspection due to non-compliance with the Alberta Building Code and the Safety Codes Act.
Issues and corrective actions included:
1. Aluminum J and corner trim does not allow for the plank to be sealed (caulked at termination).
Corrective Action: Install 5/4" Smart Trim and color match caulk at all terminations.
2. Flashing detail on primary head flashings are cut and bent, creating point of entry on each end dam at the back side of drip.
Corrective Action: Install new primary head flashings using the fold method to create end dam.
3: Incorrect stagger on plank install, Not enough distance between butt joints on stagger, no slip plates at butt joints.
Corrective Action: Install new plank using a either a 24" or 32" stagger pattern, with aluminum slip plates behind all butt joints.
4: Many terminations through plank siding have no trim block, not sealed correctly.
Corrective Action: Install 5/4" trim blocks to allow plank to be sealed(caulked to termination.
At the end of the project, a final inspection was completed and the local county passed the building permit inspection.

Complete roof replacement in New Oxford PA 17350 near Hanover 17331. Tear-off existing roof, install new flashing, ridge-vent, ridge-cap, drip edge, underlayment, roof deck repairs, flashing, GAF Timberline HD LIFETIME-warranty asphalt shingle roof replacement. https://superiorservicespa.com/roofing-contractor-pa-md/

Inspiration for a large transitional beige two-story exterior home remodel in Toronto

Closeup of the copper valley flashing on this historic Saltbox-style Farmhouse erected in 1779. We recommended and installed 3,000 square feet of G&R Red Western Cedar on this expansive residence. This material is very consistent with roofs from this era. We flashed all valleys, vents and chimneys with soldered copper.

The counter flashing is the metal that is visible, with step flashing that is under both the shingles and the counter flashing, but not visible. This will prevent the left rater from rotting due to water exposure.

The hip roof for this structure in the Romanesque style, is timber framed oak with traditional mortise and tenon joinery. The rafter tails are profiled. The roof tiles are hand made and flashed with copper.

Inspiration for a large timeless brown three-story stone exterior home remodel in DC Metro with a shingle roof

Inspiration for a large timeless brown three-story stone exterior home remodel in DC Metro with a shingle roof
19










