Software
Houzz Logo Print
yellowlabdaisy

Bad kitchen floor tile install

12 years ago
I just had a kitchen floor install done with 12X24 tiles. I was left with major lippage, tripping on tiles. They came back (Big box tile retailer, used their contractor) tore up 4 tiles replaced them, they are better not great. Walking barefoot the floor is no uneven. They said my 3/4 inch plywood floor was enough with a layer of laticrete. Sent an email to Dave Globis, widely repected tile consultant, he said you can not install ceramic tile of a single layer of plywood". I had another tile person look at he said same thing and why didn't they use Hardie Board and the lines are off and uneven, unexceptable. No I know I want a redo or money back, guess I have a big fight on my hands.

Comments (7)

  • PRO
    11 years ago

    First of all, I only like doing 12 x 24

    tile with 1/8" spacing. The most critical is what is noted above getting the floor below prepped and level and upgraded before you start. Using the right concrete board underneath. We used 1/2" concrete board in the main areas and as we layed the tile in the operatories used 1/4" and added saddles. If you bought this floor from Lowes or home depot and they installed it then they should stand behind it. it's guaranteed. I retiled the office console with home depot glass tile.


  • PRO
    11 years ago
    last modified: 11 years ago

    Are you telling me Dave Gobis sent you an email saying you can not tile over one layer of plywood topped with Laticrete Strata Mat, or one layer of plywood by itself? If I'm not mistaken these uncoupling membranes have been approved for this application. Tiling over a single layer of plywood is ridiculous.

    Have you checked with Laticrete to find out what their take is?

  • PRO
    11 years ago
    last modified: 11 years ago

    Did you get a chance to call Laticrete?

    I just set some 1'x2' tile over Stratamat on my last project. Kept the grout joints nice and tight around 1/16"-1/8". You will notice that no lashing system is needed when the installer has some skill and takes pride in their work.

    There is an action shot. The Strata mat looks loose layed because I set it with white thin-set. Works better to use gray. I used some rapid curing thin-set from Ardex called X32 to set the tile. The install is now grouted and looks fantastic.

    To put my mind to rest I'll email Laticrete myself and ask this question of them.

  • PRO
    11 years ago
    last modified: 11 years ago

    Just re read the tech sheet on Strata mat and found that 3/4" ply is OK

    Here is the Spec Sheet: Stratamat IDS0260.pdf

    Your tile guy could have at least done this to improve the chance of a good installation. The photo's you post show sloppy work and that would not have changed by just adding Strata Mat.

  • 11 years ago
    last modified: 11 years ago

    No 1/2 offset. 1/3 offset max. With medium bed mortar and minimum 3/16 grout line unless you use a leveling system. And extensive floor preparation. Get the new TCNA handbook. It lays it out in black and white and it's hard for a contractor to argue with the governing body for his trade, even if he has failed to keep up with industry changes.

    If you've already paid, you're probably SOL. If you haven't, would you want the same contractor that screwed it up to try to do something beyond their expertise level?

  • 10 years ago

    with any tile, use a stiff, leveled underlayment. I prefer small grout lines. Using QEP Lash Tile Leveling tile spacers allows installer to keep tiles same height at grout lines. I got mine at home dep*t.