Sears Garage door opener keypad remote problem

18 years ago

I have a sears craftsman garage door opener with a keypad entry remote. This has been working good and now has quit. I replaced the battery and now the door just jerks back and forth and quits. The doors works fine with wired wall remote and the cars remotes. I had 2 other of the keypad remotes and have tried them and they do the same. Does anyone know what is going on? Again works great with everything except the keypad entry

Sort by:Oldest

Comments (3)

don_1_2006
18 years ago
Are these wireless keypads and are they Sears? Are they protected from dripping water? This is a very unusual problem and then multiply that by 3 units all acting the same. I would check the keypad for a sticking key.
darloma
17 years ago
Neither of my remotes work, nor my keypad. All worked fine until yesterday, then all three quit working. Keypad lights do not lite up whe touched...Craftsan 139.53976SRT. Replaced all batteries. All three are wireless, of cours. Only switch that works to open the garage door is the hard wired button on the garage wall. HELP hapmar23@aol.com
Related Professionals
Reading Landscape Architects & Landscape Designers · Lake Oswego Landscape Architects & Landscape Designers · Mitchellville Landscape Architects & Landscape Designers · Waterbury Landscape Contractors · Mendota Heights Landscape Contractors · Natick Landscape Contractors · Ronkonkoma Landscape Contractors · South Lyon Landscape Contractors · East Norriton Landscape Contractors · North Hills Landscape Contractors · Huntington Decks, Patios & Outdoor Enclosures · St. Louis Decks, Patios & Outdoor Enclosures · Ellicott City Home Builders · Manassas Home Builders · Pine Bluff Home Builders
ddhump1955_sbcglobal_net
15 years ago
Keypad and remote control to my GDO have been operating fine.
Then today when I tried to close my GDO with my remote it would not work. I tried the one in my wife's car and it would not close the door either. So, I got out and attempted to use the remote pad and it would not operate. Both were purchased about a year and half ago and installed at the same time. What could the problem be that would stop them from opening my GDO?