Should work. Set your program in B first. Then just follow the directions on p26 and p30 to do your manual program run and set your delay.

http://www.hunterindustries.com/sites/default/files/OM_ProC_EM.pdf

Got station B set up for 3 min. running times & when I set up the 3 min. delay (for air compressor recovery) that looks good. Problem is when I set up station A for the seasonal watering & try to set a 45 min. delay, it changes the 3 min. from Station B to 45 min. Looks like it is allowing only 1 choice of pump delay for all stations. I am sure this is an operator error. Hope someone knows how to assign different delays to each station.

It looks like in this case, the delay applies to all stations, no matter the program.

This post was edited by irrigirl on Mon, Nov 3, 14 at 10:33