Software
Houzz Logo Print
tsheehan7

'One-sided' Crape Myrtle

18 years ago

I've got a single stem Natchez crape myrtle planted in my back yard. When I purchased the tree at the nursery, it seems to be fairly symmetrical. When the nursery delivered and installed it, they broke off a branch. With that branch gone, it exposed to me for the first time how truly lop-sided the tree really is.

The tree was installed last March and it was estimated to be about 5 years old at the time. I didn't sweat the broken branch, especially since crapes have a reputation for being so indestructible. I was told that crapes tend to focus growth on "injuries", so I made a couple of 1/4 cuts in the trunk of the tree on the side that lacks branches.

A year later, I still have a lop-sided tree. The cut in the trunk has healed over, but no branches have sprouted out. I made the cut in May, so it could be that it was too late at that point.

At any rate, how can I promote branch growth on that side of the tree? Secondly, I'm scared to really prune any of the branches this spring because I want the tree to fill out properly. Any suggestions would be appreciated.

Comments (4)

  • 18 years ago

    If you get lucky suckers may appear this year then you'll have a mutiple stem. Never heard of injuring the trunk to induce branching. If you didn't prune the branch back to the stem do so and more than likely it will send out a couple more branches.

    Here is a link that might be useful: Propagating Perennials

  • 18 years ago

    That poor crape myrtle!

    Your first error was in allowing the damaged tree to stay on your property. Any kind of handling or planting injury is unacceptable. Crape myrtles may be tough, but a branch loss can cause permanent disfigurement (as you now know).

    The second mistake was in cutting into the trunk of the tree. Woody plants DO send energy resources to the site of wounds, but the location determines just what will happen. Slicing into the trunk will not induce branching. Topping a tree can result in a mass of unattractive new growth just behind the pruning cut. This is typically done on the branches, but I've seen crapes and other trees hacked off to 6 feet or so, only to grow an absolute huge mass of branches at the site of the cut. You'd be able to maintain your single trunk, at least.

    If you were to cut your tree to the ground, you'd have the opportunity to begin all over again, shaping your tree to the form that you want, though it would be very difficult to get a single trunked specimen that way, I should think.

    I personally wouldn't follow either of these procedures because a great deal of the attraction of crape myrtles is how gorgeous they can look 'naked' with those beautiful bare bones. Natchez, in particular! But, at least, those are a couple of options for you.

  • 18 years ago

    Rhizo, while it would take a while (4-6 years) before the trunk(s) looked like the "muscular" one the CM now has, the appearance IS a function of age, and will recur. If a strong shoot is selected after a year's growth, then in time, the tree will look much as it does now - only better as it won't have been topped. You would have to contend with a strong tendency to grow shoots, for at least several years, but all my 1-gal. CM's did that after planting (in 2002) anyway - I am still doing some annual shoot removal - in fact, I should be out there cleaning up 2 now! It is certainly possible to select for a single-trunk, you just have to decide on which shoot you want, and be persistent.

    And if the CM will make shoots from the bottom now, without cutting down, then one or more of them can be selected - perhaps with an eye to the eventual ease of taking out the present trunk - and eventually the existing trunk can be removed and the replacement take over - this would shave a year of so off the time of replacement. But, it depends on if the CM will produce nice shoots from the base or not....

    Regarding pruning - the general practice is to make light cuts for moderate growth, and severe cuts for more growth. BUT, that applies to established trees with a good root system, and also ones which grow well from pruning. While CMs will grow after pruning, if there are no branches on that side, there are none to "encourage", plus it was trying to grow a good root system to sustain itself. You COULD top it, but PLEASE DON'T!

    If you don't want to wait for the general appearance to meet your prior expectations, I would contact the nursery, and ask that the CM be replaced, if they gave a year's guarantee. While it isn't dead, nor likely to die, it isn't satisfactory to you, and that as a result of their employees' actions. As a matter of good will, they SHOULD replace it - although they may not be so inclined, also.

    And, another time, if a branch is broken in installation by a nursery crew, and if you don't like the looks after the break, have them pull it then and insist on a replacement of your choice - don't accept their mistake nor their assurances that "it will look fine after it grows in".

  • 18 years ago

    I guess I'll just hold out hope that the tree will send out a new branch in the area where the old branch is broken off. I don't want to top the tree, nor do I want to cut it to the ground.

    Maybe it didn't send out a new branch because the injury occurred right when the tree was planted. Maybe now that it's established it will attempt to regrow the branch on that side? Something tells me that's wishful thinking.

Sponsored
J.Holderby - Renovations
Average rating: 5 out of 5 stars4 Reviews
Franklin County's Leading General Contractors - 2X Best of Houzz!