Software
Houzz Logo Print
deanriowa

Improved cheap tomato cages idea

19 years ago

My first year back growing tomatoes and I bought lots of those small cheap wire tomato cages(36" I think), and they work fine for smaller determinates, but for the larger indeterminates they are too short and fall over.

My idea is to take two of the cages and and connect the big ends(big end to big end) with zip ties. This ought to give the height needed. Then to stabilize it, I thought, I could use a cheap electrical fence rod pounded in the ground to support and hold the cages from falling over.

Total cost should be about $3.50.

Any thoughts?

thanks,

Dean

Comments (4)

  • 19 years ago

    I don't know your weather, but where I live, I have found the only way to grow tomatoes is to build cages from concrete reinforcing mesh, approximately 2' diameter.

    Every cage must be supported by at least two 1/2" diameter concrete re-bars pounded at least 18" into the ground, wired to the cage, and at least as tall as the cage.

    It is almost impossible to stand upright a tomato plant and tuck it back into the cage after a 70mph wind has flattened the whole deal.

    I feel really slighted that Kansas hurricanes do not get the media attention gulf coast hurricanes get.

    Tom

  • 19 years ago

    Hi Dean

    I did the exact same thing this year. The toms maxed out at about 7' tall. I improved the setup by laying some scrap lumber 1"x1"s 4' long, horizontally across the circular wire supports. Zip tide em' on, 4 on each hoop, perpendicular to each other. Sounds like I'm writing a technical manual eh?

    Anyway it works good.

    I ate too many BLT's yesterday.

  • 19 years ago

    Many years ago I made a mistake and made the first tomato cages that I ever made out of Concrete Reinforcing Wire too short. The mistake was cutting the wire in half horizontally first before cutting it off to curl up to make the cages. Consequently, they were all too short for indeterminates, but I have made do with them by also using tall bamboo stakes along with them, until this year. I made tall CRW cages out of a big roll and they are working beautifully. Some of the tomatoes are now taller than the cages and some are drooping over to grow back down toward the ground but I do not think that any will reach the ground. If it looks like they will, I will figure out something to do like putting a few bamboo poles horizontally through the cages and tying the tops of the plants on to them.

    I am using the old short cages for smaller tomatoes and also for pepper plants as shown below.

    They are easy to stack and tie together which makes them more useful. I started late with my peppers, they had a struggle with over two months of torrential rains, and grass growing up around them but have finally started bearing abundantly. Several branches loaded with peppers have broken off and they are getting too tall for the short cages so I decided to start stacking them. I just did that one this morning and the plant will soon straighten up like it should be.
    Bill P.
    {{gwi:103980}}

  • 19 years ago

    You pretty much get what you pay for. In my younger days my mother read me a story about three little pigs. While I'm not sure that the story was meant as a lesson for tomato growers, it makes perfect sense to allow tomatoes to achieve their full potential, even if they grow to 20 feet or more. The only system that I'm aware of allowing one to support unlimited vertical growth is the wrapped stringline support using an overhead framework. It may cost a bit more initially but how many of you drive a car instead of pushing a wheelbarrow to do your grocery shopping?