Software
Houzz Logo Print
jwoair23

French Drain Engineering Questions

19 years ago

Well I am trying to plan a french drain project to alleviate water coming into my basement. I've got a lot of engineering questions, if anyone can guide me in the right direction I would appreciate it! First some background. As you can see from the picture, my roof has a main section that then runs down in the front to a patio roof angle in the opposite direction. The problem is my attic is finished with vaulted ceilings, so that this melts the snow, runs down to the patio roof, and forms ice dams in the gutters. This is an issue I'll address at another time hopefully, if there is even anything I can do about it.

The symptom is that I am getting water in my basement in the coal room that is below the patio. To help solve this, I plan to install french drains all around my house. The front of the house is labeled, and there is a steep grade that goes towards the rear of the house. On each side of the house are cement steps, which are attached to my neighbors houses. My plan is to dig a trench between the steps and my house, lay down fabric liner, put down 2-3 inches of washed gravel, lay the french drain on top of this, fill the trench with washed gravel, then lay 3" of red lava rock covering the whole surface area between the cement steps and my house. I think (hope) this will work pretty well and look nice as well, but I have a few questions:

1. How far in " do I want the drain from the house on each side?

2. How deep do I want the pipe to be sitting in the ground? Remember my goal is to prevent water from seeping into the walls in my foundation.

3. What is the best way to route my drainage pipes from the downspout to the rear of the house down the grade? Right now there is flex tubing running just underground down the house to the rear from the downspout, can I connect this to the french drain (I'm thinking no?) if not how should I route it so it doesnt interfere.

4. Do I want the holes up or down, assuming they are on one side?

5. Do I want to use solid piping or flex piping?

Right now grass is in the front and dirt on the sides, so I am hoping this solves my water problem, and also gives me an opportunity to landscape around the perimeter of my house. Which brings me to my last question, will it be safe to plant anything in the front of the house, like a shrub, or will roots interfere eventually with the drain?

Thanks for any insight you can provide!

{{!gwi}}

Comment (1)

  • 19 years ago

    I don't know where you live. Where I live, we have to put drainage tile right next to the concrete footing that the house sits on. The water that reaches this tile is either fed to the storm sewer system under the street or into a sump pit sunk into the basement floor where a sump pump sends it out to the ditch.

    When water starts coming into a house, it often means that the drain tile is now blocked with silt and cannot do it's job. Also, basement walls constructed from concrete block often develop cracks in them that allow water to seep through. Poured concrete walls can also develop shrink cracks. Both types of walls benefit greatly from the use of a waterproof membrane such as Platon or something similar.

    If you use the link below, the diagram is self-explanatory.

    It's hard to say where your water is coming from. The water table in the ground changes from one season to the next. In the summer, the table can be low enough that no water will come into your basement but in the spring it can rise substantially. A french drain won't solve that problem. French drains only work for water that is on the surface or coming out of the sky.

    Any water in the ground that is lower than the French drain will just find its way into your basement if there is an opening for it to go through.

    Your best remedy is to excavate all around the house, right down to the footing level. Remove the old footing tile. Lay down one inch of clear 3/4" stone. Install 4" perforated flexible drain tile that has a filter cloth sleeve on it. Use stakes to keep it in place against the sides of the footings and then pour more 3/4" clear stone over top of the tile until it is at least four inches above the top of the pipe.

    I would then install a blanket of filter cloth over top of the clear stone prior to backfilling but I would also install the Platon membrane too, in accordance with the instructions that come with it. Of course, this new tile must be hooked up to your sump pit or the line out to the street in order for it to work properly.

    Anything less than this is not likely to give you a permanent fix. Water coming into a basement render that basement useless and it's also a health hazard due to mold and mildew.

    As for your roof issue, that's due to inadequate insulation in your ceiling joists. You either rip out all the existing ceilings and tacke the problem from inside the house or you remove the shingles and roof deck and insulate properly from the outside.

    Here is a link that might be useful: Platon