Software
Houzz Logo Print
tekbro

Icemaker Install Water Tie-in

17 years ago

Hi folks! I am the owner of a 1963 Brick-on-frame ranch home on a crawlspace. In the kitchen, I have a fridge with an icemaker/water filter&dispenser. There is a copper line that comes up through a hole in the floor behind the fridge already installed. the copper line ties into the water line in the crawlspace, directly under the kitchen. The tie in is made using a self-peircing saddle valve, which has long since clogged and is no longer operating. I disconnected the line from the fridge, crimped it and abandonded it in place.

I want to put a "proper" water connection in, where you put a tee in the water line. But rather than do the tie-in in the crawlspace, I'd like to keep it all in the kitchen, and tap in at the cold water inlet under the sink. Then I will fish the new line behind the cabinets and finally to the back of the fridge, leaving room to pull the fridge in and out.

The trouble is, I'm not sure what I've got here. I *think* my water pipes are galvanized steel, vs. copper. Under the sink, the hot and cold nipples from the wall are connected to the faucet via 1/4" (I think) braided SS hoses. But the transition fittings between the pipe and hose are these shiny, silver colored fittings that look almost like pneumatic fittings. I think the fact that they are threaded fittings means it should be easy to incorporate a tee into the line at that point once I shut off the water. Can anyone tell me what these fittings are and also, what fittings I would need to connect my 25' of "poly" to the cold water line?

Comments (2)