Software
Houzz Logo Print
sequoia_2007

Drywall Seams Around Window Openings

12 years ago

We hired a drywall contractor to drywall our 1st floor townhouse recently. We took the walls in the kitchen, dinning room, living room and landing down to studs to repair many problems within the walls.

While they were applying drywall around a large picture window, 6 foot by 6 foot, I noticed the horizontal seams were 2-1/4" below the header and at the sill. I also noticed they were butt joints. I expressed my concern to the lead drywaller, but he insisted it would not be a problem even though we live in a seismic area. I was always under the impression that horizontal and vertical seams around windows and doors should always be well away from headers and sills. I suspect this was done because they were short material and they did not want to hold up the job waiting for more material to be delivered.

So instead of using two pieces of drywall with beveled edges at the seams and routing out the opening. They used four pieces of drywall with butt seams at the header and sill.

This drywall contractor was highly recommended. He just returned my call to him regarding my concerns. He said butt seams at the corners of windows were common and he does this al the time in the multi-million dollar homes that he works on. I am curious what others in the trade think about butt seams at the corners of windows.

Thank you for taking the time to read my post and consider my concerns.

Comments (8)

  • 12 years ago

    Is it blueboard or taped drywall?

  • 12 years ago

    Taped drywall with a smooth Level 4 finish on this wall.

  • 12 years ago

    IMO, it's a hack job. You should not have the drywall end at the window opening, it should at least go 6 - 8" into the opening. The upper doesn't look bad - but the lower one does.

  • PRO
    12 years ago

    I'm with your drywaller. Those seams aren't going anywhere.

  • PRO
    12 years ago

    Technically, you are right; the drywall manufacturers prohibit butt joints as done here, but since the joints will probably be covered in casing, I'm not seeing a problem if they fail.

    Here is a link that might be useful: Joints

  • PRO
    12 years ago

    Technically, you are right; the drywall manufacturers prohibit butt joints as done here, but since the joints will probably be covered in casing, I'm not seeing a problem if they fail.

    Here is a link that might be useful: Joints

  • 12 years ago

    If we use three inch wide casing four inches of drywall will still be exposed. This is a presentation window and cracks at the corners of the window are unacceptable to me.

    We had a lot of serious issues in our home due to ghetto construction by the original builder 30 years ago and subsequent contractors. I spent the better part of the last year reframing and planning the walls to make them plumb and flat and used 18 gauge metal studs to level and flatten the ceiling. I made it clear I wanted full sheets used along with a Level 5 smooth finish. We paid 4,000.00 for this work.

    Looks like my wife and I will have to rent a truck to pick up two sheets of 5/8â 54â wide drywall and redo the wall. I will ask that their tape & finish person completes the work. He has to come back anyway since he forgot to sand many areas.

  • 12 years ago

    If you specified that you wanted full sheets and a Level 5 smooth finish, and those specs are what the $4000 is based on, then that's what you should have gotten.

    You should not be renting a truck, picking up drywall and installing it. Have the contractor do it.