Software
Houzz Logo Print
atct86

2.5' for Crown Moulding??

16 years ago

I am about to install my Kraftmaid cabinets in my rehabbed house. The height of all my cabinets is based on the height of the cabinet which goes on top of my 72" Viking Fridge.

with 2.5" being leftover on top, should I move the cabinets to the top, or try and find a small crown moulding?

Comments (7)

  • 16 years ago

    I think you can find a nice 2.5 inch crown or a stack that adds up to 2.5 inches.

  • 16 years ago

    If you push the wall cabinets up to match the height of the cabinet over the fridge, how far would the bottom of the wall cabinets be from the top of the countertop?

  • 16 years ago

    yeah, gotta have the crown. Is it possible to bring the cabinets down just a bit to accommodate larger crown? It really finishes off the room to have the most amount of crown.But if not, like other posters said, any crown is better than no crown. good luck

  • 16 years ago

    My cabinets have staggered height. the cabinets over sink and range are 6" higher and match up with the over fridge cabinet which is 2.5" from ceiling.

    The over the fridge cabinet is 30" high and is on top of a 72" high fridge, so there really isnt mutch room to play unless I just put that cabinet at that height.

  • 16 years ago

    Personal taste, with a crown that small rather than the usual 45 degree crown I would use one that is more upright that appears to have less of a face angle (I hope I explained that ok). I wouldn't move the cabinets up. I have a 18 1/2" space and I'm fairly tallish (5'7") and I wish it was lower. If I was to ever do another kitchen I would make the uppers just tall enough to clear my appliances.

  • 16 years ago

    I just encountered a HUGE problem this weekend with crown moulding and staggered height cabinets. Unless someone on here has a different way to install the crown that I don'tknow about, we could not install crown on staggard height cabinets without pulling the highest cabinet out the depth of your crown OR do a strange cut back angle on the crown on all the shorter cabinets.

    If anyone on here has the answer to this problem please share it before I loose my mind...LOL

    I did find a beautiful trim though that is a straight trim that has a crown affect that I am going to use to keep from bumping my undercabinet hood/ 18" cabinet forward.

Sponsored
AIS Renovations
Average rating: 4.5 out of 5 stars15 Reviews
Custom Craftsmanship & Construction Solutions in Franklin County, Ohio