Software
Houzz Logo Print
akjr_gw

New sink drain "glugs"?

11 years ago

We are in the process of updating our kitchen. We put in a new single bowl sink. After hooking up the drain, we find that the new sink does not drain as well and "glugs" as it does so. The prior sink was a double bowl. It doesn't glug when the dishwasher discharges, though, only when pouring large quantities down the drain. Is there an issue with installation? Or is this a difference with a one bowl sink versus two? Any insight appreciated! Thanks!

Comments (14)

  • 11 years ago

    Is there a garbage disposal unit in your new sink?


  • 11 years ago

    Sounds like a venting issue. Check to see if the vent line has debris in it.

  • 11 years ago

    There is a garbage disposal. It is the same one we had used previously, slated to be replaced when the new one comes in. We can check the vent but the vent lines were not disturbed during the sink change. Thanks for the ideas.


  • 11 years ago
    last modified: 11 years ago

    I agree with Sophie, this sounds like a venting issue. You didn't notice it when you had two basins, because one would vent as the other drained.

  • 11 years ago

    This makes sense, Errant. We'll put climbing on the roof on the weekend to-do list.

  • PRO
    11 years ago

    Pictures of the trap and drain lines, please.

  • 11 years ago


    Does this help?

  • 11 years ago
    last modified: 11 years ago

    Hard to tell from the angle of the photo, but first question is the new sink deeper than the old one?

    The drain outlet into the wall looks like it may be at or about the same level or higher as the disposal outlet. This is a no-no, as water will not go uphill on it's own.

  • 11 years ago
    last modified: 11 years ago

    A clogged vent is possible, but I've not personally ever seen that. On the other hand new installation and then problems...I'd be looking there. I assume the vent is in the wall since the old sink worked. The trap to me looks very low. It should work, but that is a lot of water sitting in the trap. I'd want to get rid of the two 90's closest to the wall (can't really see too well). That would rise the trap up higher, less water to push.

    Also all the dirt in the water settles in the trap. Normally not a problem, but more water = more settling could mean more future clogs.

  • 11 years ago

    Thanks for all the tips. We'll taking this all apart today to install the new disposal. The new sink is deeper but the drain outlet into the wall is 3/4" higher. And yes, the vent is in the wall. We'll rework it to get the trap higher and eliminate the 90's as much as possible. Thanks again!


  • 11 years ago
    last modified: 11 years ago

    What a mess under there! My venting suspicion is confirmed. The cheater vent (studor) is on the wrong side of the trap to begin with. And shouldn't have been used in the first place. The whole mess needs to be ripped out and redone.

  • 11 years ago

    I'm not sure what you are calling a "cheater vent"? The r.o. connection? It doesn't currently have a hose connected because we don't have the water on yet. There isn't anything for venting purposes, perhaps the picture gives the illusion of one?


  • 11 years ago

    But if it makes you feel better, it is completely ripped out and in the process of putting in a new disposer. It is a tight space so likely it looks worse in the pic than it does in real life. Just for the record, it meets all requirements according to the manufacturer's installation guide and local plumbing code. We were just looking for suggestions to improve it.


Sponsored
Bella Casa LLC
Average rating: 5 out of 5 stars17 Reviews
The Leading Interior Design Studio in Franklin County