Software
Houzz Logo Print
helsharmar

What could cause "click" when switch is turned on?

11 years ago

Some rewiring was done during a bedroom remodel, and now, when I turn on the ceiling fan, I hear a "click" but only when the switch hasn't been used for a while (hours or more). If I turn it off and back on right away, I don't hear the click. This is one of two clicks for the fan. The other one, which was the original and only switch for the fan, doesn't make any sound.

The sound itself isn't a problem, but I'm concerned that it may indicate a wiring problem. I first heard this sound right after the work was done, and the electrician said some wires were crossed between that switch and the nearby gas fireplace. He said he fixed it, but if so, why do I hear the click again? The contractors are gone. What can I do to test this, and, if necessary, fix it?

Comments (5)

  • 11 years ago
    last modified: 11 years ago

    Is this a newer switch? I wonder if there is a fan canopy module engaging that controls the light and fan. Is your switch like one of theses?

    http://www.homedepot.com/p/Lutron-Maestro-1-Amp-Single-Pole-7-Speed-Combination-Fan-and-Light-Control-White-MA-LFQHW-WH/100576179

    It allows for fan and light control, with only one electric run instead of two. It has the dimmer in the wall plate and a control module in the fan canopy that communicates with the dimmer.

    helsharmar thanked Vith
  • 11 years ago

    I'm so ignorant about electricity-related items, that I'm not sure I can give correct answers, but I'll try: There had been a light switch there but I don't think the fan switched there (hard to remember). The fan used to have just one switch by the bed. The switch looks nothing like the link you sent. It's the more conventional type of on/off (up/down); there are 2 switches in the location of concern. The 2nd is for the room lights (sconces), which are not part of the fan. No dimmers.

    What concerns me most is that I told the electrician about a previous click, and he was so nonchalant when he told me the wires were crossed with the fireplace. I could swear he fixed it, but it's either back or never went away. The electric inspection passed, FWIW.

  • 11 years ago
    last modified: 11 years ago

    Hmm, some things click when you plug them in or first give them power. I wonder if there is something else connected to that switch's wiring, possibly the fireplace you mention. Does that fireplace operate with the switch off? Probably going to have to have an electrician diagnose, it might be something else, hopefully there is no hidden junction somewhere between the fireplace, switch, and fan canopy.

  • 11 years ago

    The way the FP is set up, we were told to leave the switch in the "on" position and use the remote to turn it on/off. When you say "some things click when you first give them power," are you saying that can be normal? Would that jibe with the fact that it doesn't click if turned on and off and back on within a short time span? Is any of this something the electric inspector should have examined?

  • 11 years ago
    last modified: 11 years ago

    Yes, some devices have an internal switch that gives an audible click when it is given power. It is basically going from a zero power state to a standby state. The device is now awake awaiting command instead of being dead.

    Since it seems the switch controls both your fireplace and your fan, then you need that addressed, and you are correct the previous electrician did not do anything about it.

    Another concern is to find out how much amperage this fireplace requires and if it should have its own line to the panel and its own breaker.