Software
Houzz Logo Print
rorycn

It this a backflow preventer?

10 years ago

The Water authority does not have on file that we have a backflow preventer. Plumber is coming next week to do a dye test so we can close on our house. If there is no backflow preventer plumber will need to install one.

Is the cone shaped thing by my meter a backflow preventer?


Comments (5)

  • 10 years ago

    That is a pressure regulator, used when the incoming water pressure is too high. It also acts as a check valve which is why a pressure accumulator is also required. It acts somewhat as a backflow preventer but may not satisfy the federal requirements for irrigation systems, if that's your issue.

    Rory (Zone 6b) thanked randy427
  • 10 years ago

    Thanks! So I guess I don't have a backflow preventer. What is a ball-park figure for getting one installed?

  • 10 years ago

    The cone shaped thing on the left is a PRV (pressure reducing valve) and they usually have a backflow preventor built in, but not always.

    IIRC backflow preventors that create closed plumbing systems in houses have been code since the mid 90's

    If it does have a backflow device built in there should be a thermal expansion tank installed at the water heater cold inlet.

    If you do install a backflow device you must install a thermal expansion tank.

    Rory (Zone 6b) thanked User
  • 10 years ago
    last modified: 10 years ago

    Ask the local authority what they require. I had a standard backflow preventer that came with the house, and, when it was time for the required annual check, the inspector noticed that it was not quite the right one for our installation, and I had to replace it with an almost identical one that had one differently designed orifice.

    I installed my own. I bought the correct valve online for about $125 (the same thing was $300 at the local supply house). I cut into the piping, added unions to the valve (for easy maintenance removal), and resoldered the piping; this added about another $60 in materials. It would probably take a plumber an hour to do if access is easy. I'm guessing you are looking at $500-1000, parts and labor, depending on where you live. Expansion tanks are cheap (maybe $30), but there will be more repiping for that, too.

  • 10 years ago

    I do have an expansion tank on the water heater. Does that mean the PRV has a backflow preventer?

Sponsored
High Point Cabinets
Average rating: 5 out of 5 stars21 Reviews
Columbus' Experienced Custom Cabinet Builder | 4x Best of Houzz Winner