Software
Houzz Logo Print
michael_batts73

Toro Recycler cord won't pull, engine trouble

10 years ago
last modified: 10 years ago

While mowing, engine started sputtered and stopped. Can't pull cord, won't start.
Checked oil, seems like that's not the issue.
I did notice an engine mount bolt had sheared (since fixed), not sure if that contributed to the issue.
Waited a day, moved blade by hand. Cord was able to pull, engine started, sounded rough. After 30 seconds it's seized up again. Any thoughts?

Comments (9)

  • 10 years ago

    Apparently it seized up , check your oil again and see if you smell any gasoline within the oil off the dip stick . If no then pull the spark plug and look for any shiny alluminium particles or a very light tan or white colouration . No , check the engine by pulling the recoil again with the plug still out , does it pull over easily or drag and stick ? Otherwise it could also be a valve train or ring issue . Did you notice any abnormal smoking or noise prior to the engine faltering ? Oil level was not overly full or low on the dip stick ? Did you hit anything prior to the motor mount shearing ?

  • 10 years ago

    No abnormal smoke or noise, no. Didn't hit anything, but was mowing at an angle into a drainage ditch. Dipstick level may have been high.

  • 10 years ago

    4 strokes don't like angles..

  • 10 years ago

    Probably ran dry of oil due to the steep elevation . Check the plug as advised and get back to us .

  • 10 years ago

    Sounds like he got oil in the intake tract, hydraulically locked the engine, shearing a mount bolt, now he has an oil-soaked air filter. Just another possibility.

  • 10 years ago
    last modified: 10 years ago

    All depends on duration of mowing on how steep of an incline Sax ? Won't know until "M" gets back to us., These Newbies sure are slow at getting back with further information , Just saying !

  • 10 years ago

    No gasoline smell in the oil/dipstick. Pulled the plug, some white coloration.


  • 10 years ago
    last modified: 10 years ago

    White indicates overheating condition , you may have partially seized the rings to the cylinder and or scuffed a piston . How much time were you cutting on the incline "M" ? Try putting some transmission fluid 1 ounce within the cylinder via the spark plug hole . Let it sit overnight and then restart the engine and observe the sound and vibrations if any . You may get lucky and if a valve stuck or ring partially seized it may release with the solvency of the trans fluid soak and start . If engine sounds normal I would pick up some Lucas Top end lube and treat your Fuel and Oil accordingly . If you can't find the lucas product try some MMO (Marvel Mystery Oil ) . P.S. Hydro lock not out of the question , especially with the sheared motor mount , potentially overfilled oil , but engine would have displayed a mis and surge and visiable smoke prior to locking up , both times ? Check your air filter as Sax advised 1st , is it fouled by excessive oil ? No , Give the cylinder a shot glass of Tranny Juice !

  • 10 years ago

    You would think so. Its almost impossible to seize it by running it on a slope as long as the proper amount of oil is in it. Generally it will cut off from oil ingestion before any real harm is done. But it is what it is - sure sounds like a scored cylinder. But why is it not blowing oil when it runs now?