Software
Houzz Logo Print
dmullin88

How to remove Baldwin handleset for repair?

9 years ago

Greetings,
I am trying to remove a Baldwin handleset from my kitchen door so I can lubricate the interior of the mechanism, which currently sticks. I think I should be able to just pull off the panel you see in the attached photo once I have removed the two screws and the handle, but it seems really stuck. It might just be stuck to the paint, but before I try to more aggressively pry it off (which will certainly mar the paint and maybe the hardware), I just wonder if someone could confirm for me that there is not some hidden screw or something holding that panel in place? In other words, do I just have to pry it off now. Thanks!


Chuck

Comments (5)

  • 9 years ago
    last modified: 9 years ago

    I suspect that the plate is just stuck to the paint. If it were me, I'd take a razor blade and carefully work it around the perimeter of the plate with the blade parallel to the face of the door. Then I'd get a non-serrated, thin blade like a steak knife and try to gently work it in between the face of the door and the back of the plate. if you're careful, you won't mar the surface. if it needs a bit more persuasion, you can lightly rap on the back edge of the knife with a hammer as you are working the knife around. Alternatively, if you have a sharp chisel, maybe 1 inch wide, you can work around the perimeter of the plate with light hammer taps, holding the back of the chisel parallel to the face of the door.

  • 9 years ago

    If the screw channels are deep enough, slide in a Phillips screwdriver, not a skinny one, into the channel and use that as a pivot. Any damage will be hidden.

  • 9 years ago

    Only after kudzus help.

  • 9 years ago

    Thanks all! Problem solved: I gently pounded on the side of the panel with a rubber mallet, and when it budged, but only very slightly, I learned that that ring you see in the photo (that the handle shaft goes through) needed to be unscrewed and removed. It was holding the panel on, and I apparently tightened it supertight when I installed the lock years ago. I lubricated the entirety of the locking mechanism, but sadly the tongue-sticking problem is only about half-resolved; I think when I drilled out the hole in the door to install the lock in the first place, I left the fit a little too snug, and that might somehow be restricting the mechanism a little bit. I'll leave that until another day.

  • 9 years ago

    Dorothy-

    Good work, and thanks for the explanation. I noticed that ring in your photo, but from that angle it looked to be only decorative. That's useful info....