Software
Houzz Logo Print
bpath

Rinse Aid Dispenser-filling woes

9 years ago

I really like my Bosch dishwasher (with third rack!). It's quiet, and it dries well overnight, when the Rinse Aid dispenser is full. It even lets me know when to refill it, since it's impossible to see how much it holds. And that's the problem. The designs of the reservoir and of the bottle are not compatible with accurate, spill-free filling.

Does anyone have good tips for:

1) getting the Rinse Aid into the dispenser on the first squirt,

2) without overfilling the reservoir,

3) without spilling outside the dispenser?

Comments (17)

  • 9 years ago

    Use a funnel. Or transfer the rinse aid to another container such as a condiment squirt bottle.

    bpath thanked dadoes
  • 9 years ago

    Chris, that is SO ridiculously obvious!!!!

    Thanks for sharing. I didn't think of it. (FP DW--rinse aid splooshes every time!)

    bpath thanked Fori
  • 9 years ago

    Lemi Shine rinse aid has a handy little rubber stopper which prevents spilling until you squeeze the bottle (like those newer bottles of ketchup).

    bpath thanked littlegreeny
  • 9 years ago

    Kitchen aid owner here and I either sploosh or take the time to reach for a funnel. It will be my finger from now on, but not for a bit - I just filled the darned thing last night. Did the sploosh, the funnel was two steps away.

    bpath thanked morz8 - Washington Coast
  • 9 years ago

    I use Miele rinse aid. They recently redesigned their bottles. It doesn't pour until you squeeze the bottle. Big improvement!

    bpath thanked theclose
  • 9 years ago

    I'll have to add Miele to my shopping list. I just bought a few bottles of Finish (darn Costco) but the machine seems to go through rinse aid pretty quickly. I can't wait to have to fill it again and try the new method.

    How do you know when to stop? I can't see when it's getting full, and by the time it's full it's overflowing.

  • 9 years ago

    Ok I have to ask. Don't you think about the fact that rinse aid is on all your glasses and dishes and you end up eating or drinking a bottle of rinse aid? It's in the final rinse, right? I never use it because of that. Just curious.

  • 9 years ago

    @bp I give a few good squeezes and then slow down. I can see when it reaches the top.

    bpath thanked theclose
  • 9 years ago

    I like the Lemi Shine rinse aid better than Finish and their bottle is like the Miele's.

    bpath thanked littlegreeny
  • 9 years ago

    Susan, I don't worry about it! First, I think it rinses off. Second, just a teensy bit gets dispensed in a cycle. Third, food/mouths come in contact with relatively small portions of all the items in the DW. So compared to everything else we are exposed to daily, rinse aid is not among my worries.

  • 9 years ago

    Chris, your technique worked! No spilling, no sloshing, no overflow! Thank you!

  • 9 years ago

    @bpathome. Great! I'm glad it helped.

    bpath thanked Chris
  • 9 years ago

    Susan, my dishes don't dry without the rinse aid, nor the inside of my dishwasher. Not even when using heated sanitizing rinse that I run most loads. Funny, but I'd worry more about soap not rinsed out of my laundry, then sleeping on the sheets or using the towels.

  • 5 years ago

    Just found this thread and I have the same issue even with the Lemishine. When you do squeeze it, it goes everywhere. I have tried cascade, finish, lemishine. I think they are all terrible for their purpose.

  • 2 years ago

    Cut off about a 2" piece of straw, insert it in the pour hole and it allows enough time to turn the bottle upside down and not spill all over.

  • 2 years ago

    if using finish jet-dry: take the cap off!! you tube: https://youtu.be/mxcQ4_lO2rI?si=FLBST-HK7k1UvC48 it works! the cap must be desinged to waste it!!!

Sponsored
Mary Shipley Interiors
Average rating: 4.8 out of 5 stars34 Reviews
Columbus OH Premier Interior Designer 10x Best of Houzz