Software
Houzz Logo Print
bob_cville

White wire connected to fuse

9 years ago

The tenants in a duplex that I own called a couple of days ago saying that the power was out in the bedrooms of the apartment. The place has a fuse box, so I was sure it was probably just a blown fuse. I went there first thing the next morning, and found the cover was already off the fuse box, but since I forgot to bring my multi-meter I was slightly stumped to figure out which fuse was blown, since none of them looked obviously blown, and since the fuse box doesn't have any of the circuits labeled.

I selected one fuse at random and turned it clockwise and the tenants shouted that fixed it. Yay. However I then noticed that that particular fuse had a the white wire from a piece of Romex connected to it. The wire seemed newer than others in the fuse box, in that it had "plastic" insulation jacket as opposed to the bulk of the rest of them which seemed to have cloth-covered insulation jackets, but the wire certainly didn't seem new.

The black wire from that seemed to go to a different fuse. Is there any way this setup is not a code violation? I know that with 220 volt breakers you can connect the black to one leg and the white to the other leg, but you then have to re-label/re-color the white wire to be not white. But this feels like a more serious problem than merely a wire labeling problem.

Is there any way could be right? I believe it is a Murray fuse box and it has three "pullouts" each of which has two cartridge fuses, two of them have 50 amp fuses and are labeled "range" and "lighting", the third has smaller cartridge fuses and might be labeled water heater, below the pullouts there are 8 20 amp fuses for the branch circuits.

Comment (1)

Sponsored
High Point Cabinets
Average rating: 5 out of 5 stars21 Reviews
Columbus' Experienced Custom Cabinet Builder | 4x Best of Houzz Winner