Software
Houzz Logo Print
austin_king99

Problem with Kenmore Model 110 Washer with video

7 years ago

Hello,
This summer I replaced the gear case of my Kenmore model 110.21302012 VMW after the wash cycle would not start and the lid lock button flashed indicating a failure. I had also replaced the actuator a few days before the gear case and the problem seemed to go away temporarily. I even replaced a couple of the basket suspension springs that were suspiciously missing.
For a number of months, the washer has worked fine. Today it would not start. I took the agitator out and found a strange wear on the drive hub.

In diagnostic mode, it now gives me error codes F7-E6 and F7-E5 (details at the bottom).


Here's a video of me spinning the basket and grabbing the agitator to make it stop. https://youtu.be/Gtz3U-t2I9o
Here is what the drive hub inside the basket looks like. Strangely worn down on that one side.
https://ibb.co/HHRkk88

I feel like the washer should be scrapped, even though I just put in about $200 of parts trying to keep it going. Any advice? Any favorite washing machines that seem to stand the test of time?



F7 E5 Shifter actuator fault--The main electronic control board cannot determine the position of the drive system shifter. Unplug the washer and check the wiring harness connections on the main electronic control board and the shifter actuator. If the wiring connections are okay, then the actuator will usually need to be replaced.
See the repair guide to fix it yourself--Actuator

F7 E6Motor fault --Unplug the washer and check the wiring connections on the drive motor. If the wiring connections are okay, then the drive motor will typically need to be replaced.
See the repair guide to fix it yourself--Drive motor

Comments (2)