Software
Houzz Logo Print
csummersall

Duct work through cabinet top for a recirculating range hood insert?

6 years ago

We found a recirculating range hood insert that fits all of our criteria, but now that it's here I realized I should make sure what I have in mind is actually going to work. The hood insert has charcoal filters, but there's no vent grille built into the unit as it's an insert, not a standard under cabinet model.


We have 40" of cabinets above the hood due to very tall ceilings. Can I simply attach the 6" duct and vent it out of a grille at the top or side of the cabinets? Ideally, I'd like to do a 90 degree turn and vent out the side of the cabinet as that saves us a bit of space in the second row of uppers, but either is doable. Is there anything I need to keep in mind here?


We absolutely cannot accommodate an exterior vent. It's an HOA and everything else is already installed.

Comments (6)

  • 6 years ago

    Photos will get you better responses.

  • PRO
    6 years ago

    Recirculating hoods don't use ducts and vents. That's the point, but photos and/or model numbers would help convey the issues.

  • 6 years ago

    It is this hood insert from Hauslane. It has a recirculating option, which is what we plan to use, but it does require that we vent that recirculated air to somewhere. I don't want to just vent it into the cabinet the hood is going to be built into, so I'd like to know if venting it out of the top or sides of the cabinets is acceptable.




  • 6 years ago

    That’s an unacceptable installation. Period. Combustible surfaces cannot be that close to the cooking zone. It says right on the instructions to follow the NFPA requirements.


    “Household cooking appliances shall have a vertical clearance above the cooking top of not less than 30 inches to combustible material or metal cabinets. A minimum clearance of 24 inches is permitted where one of the following is installed:

    1. The underside of the combustible material or metal cabinet above the cooking top is protected with not less than 1⁄4 inch insulation millboard covered with sheet metal not less than 0.0122 of an inch think.

    2. A metal venting hood of sheet metal not less than 0.0122 of an inch thick is installed above the cooking top with a clearance of not less than 1⁄4 inch between the hood and the underside of the combustible material or metal cabinet, and the hood is as wide as the appliance and the centered over the appliance.

    3. A listed cooking appliance or microwave oven installed over a listed cooking appliances with the terms of the upper appliance listing and the manufacturer’s installation instructions. Microwave ovens shall comply with Section 923.“

    The insert is only 11” deep and does not fully cover the combustible surface above. Therefore the cabinet housing it must be 30” above the cooking surface.

    This is an unsafe design and should be altered to meet safety standards.


  • 6 years ago

    @User The cabinets are mounted higher than the standard 18", and the cabinets over the stove are actually 31" above the cooktop, meaning minimum safety clearances are met. So there is not an issue with that.


    We also do have a metal sheet that will be installed with the hood as well. So not only are we 30"+ above the cooking surface, we also have extra protection. I appreciate the concern though.