Software
Houzz Logo Print
webuser_507695768

code issue? contractor to fix or do I have to pay for fix?

5 years ago

I’m having outlet receptacles put under the cabinets/shelving where ever possible to keep a clean backsplash look. I have a section of countertop with two windows and limited place for outlets- I told GC I’d like to lower the existing receptor and light switch and was told they couldn’t lower it. So I said I was fine with where it was bc there really isnt an alternative. (And I thought it was needed per code) There is 8 feet of countertop from two recepticles planned on the right under the shelving to the left-side end. I left town one day and came back to find the GC/electrical had moved the outlet and switch. Outlet to bottom left of countertop and switch to left, but higher. I told the. I did t think that was possible (for code). They assured me it was fine. My husband can’t remember if he agreed to the change or not. Now my husband (and frankly, probably any one who sees it) thinks we need an outlet at that spot. We will end up having 6 ft of countertop with no access to plug. GC is saying he can add it back in for $500. He says it’s code. I think he has some responsibility for fixing this issue. Not sure what to do.

Comments (16)

  • 5 years ago

    Can you mark on your photos where the original outlet was, where it was moved to, and where you think you need one? I'm not quite following the saga from your description.

  • PRO
    5 years ago

    He's not getting paid if there are red tags on his job, no matter whose fault it is. He'll figure that out very quickly.

  • 5 years ago

    The original switch and outlet were between the two windows- there is a divot in the wall where they were. The switch has been moved to the left. I will try to do a mark up

  • 5 years ago

    @ Joseph- he’s telling me it is code. Do I need to hire my own electrician to come and tell me?

  • 5 years ago

    He did have a subcontractor do electrical- how would this have gotten by them? Should I call them directly? Just wondering how I communicate with GC if he tells me it’s code. It wasn’t a good idea in any case- but maybe if it isn’t code he will have to fix it?

  • 5 years ago

    He overbid the whole project over what his limit with the contractors board is. When I asked him about it he said it wasn’t a big deal and he could increase at any time. Now I’m not sure that was correct info

  • 5 years ago

    So basically you had an outlet between the windows, he took it out without asking you, and now wants you to pay him to put it back?

  • 5 years ago

    Basically. Maybe my husband approved it. He can’t remember.

  • PRO
    5 years ago

    Why not raise the outlet to be up by the new switch location. Replace the BEP3 (3" base end panel) with a B9 or B12.....extend it down. Run your tile across and down to the floor/baseboard.


    If you don't like that idea, then put the outlet back between the window. What is the switch for? Drill an airswitch in to the countertop. You can use an airswitch for lots of things....not just a disposer.


    Another solution: Do an angled plugmold between the windows. Are you putting a wall cabinet back there? They will do one with a switch too.


    Or put the outlet and switch back....split it with him. I think he should eat it....but for $250...keep the peace.

  • PRO
    5 years ago

    Does anyone see the need for written changer orders? This is why we always use them.

  • 5 years ago

    If it's not in writing it didn't happen. The contractor should put the outlet back on his dime.

  • PRO
    5 years ago

    "@ Joseph- he’s telling me it is code. Do I need to hire my own electrician to come and tell me?"


    If it's against code inspection will let him know soon enough. Tell him you're not paying for any noncompliant work. If he wants to get paid, he'll bring it to code on his dime. Your electrician may have an opinion, but the code is what the inspector says it is on the day he says it, so your electrician's opinion may be irrelevant.

  • 5 years ago

    Why not make an effort to find out the requirements for your jurisdiction for yourself?

    If you live in a city, call their building department and ask. Same for county.

  • 5 years ago

    Is he saying he had to move it due to code? As in it might have been too close to the sink/water, maybe?

  • 5 years ago

    Thanks for all your help and ideas. He is going to move it for “free”. Keeps letting me know I’m getting it for “free”. But seriously, It’s very good of him.

  • 5 years ago

    We are now insisting upon change orders. This whole remodel is a learning experience I never wanted to have.