Software
Houzz Logo Print
ljsalkin

Uneven Drawer - won't close properly

5 years ago

I have a drawer in my kitchen that has been a problem since we moved in and no one seems to be able to figure out how to fix it. It doesn't close straight - the left side always sticks out about a 1/4 inch. The drawer box has been rebuilt, the glides have been replaced and the thing will won't close evenly. In addition, it doesn't close fully (it's soft close). For a while it doesn't close all the way and over and over again it comes off the glides. I'm at a loss of what to do and don't know what part of it is causing the flaw. In addition to soft close glides, it has an electronic "push to open" mechanism by Blum.

Comments (14)

  • PRO
    5 years ago

    Something is racked.

  • 5 years ago

    They're undermount slides

  • 5 years ago

    Is there any solution to an out of square cabinet box? Also, what is the best way to check if the drawer and box are square?

  • 5 years ago

    Remove the drawer and use a framing square to see if the slides in the cabinet are perpendicular to the face frame. Also see if the drawer face is perpendicular to the slides on the bottom.

  • PRO
    5 years ago

    See what type of a slide you have they have front and rear slide adjustments. If not sure there are plenty of Youtube videos explaining how to do that for different slides.

  • PRO
    5 years ago

    Doubtful it's the cabinet box or the other drawer would be out also. Play with the slides please.

  • 5 years ago

    Measure from the face of the box to the front edge of the slides. I wonder if one side is set back further than the other.

  • 5 years ago

    Get a cabinet pro.

  • 5 years ago

    @strategery Cabinet pro hasn't been able to fix it.

  • 5 years ago

    If the slides are the same to the front of the box, look at the mounting of the slides on the drawer box itself. If that is normal, consider that there could be something causing the drawer front to not be tight to the drawer box on the side that is sticking out (piece of debris, washers, etc.)

  • 5 years ago

    "Cabinet pro hasn't been able to fix it."


    Were these custom cabinets? Was the pro involved with the purchase? Have you asked the manufacturer as it sounds like it should be a warranty issue.

  • 5 years ago
    last modified: 5 years ago

    Your Blum push to open should have these tabs at each side of the cabinet


    see how that sticks out a bit? That is so you can ”push” to open. When you push the tab retracts, your trash holder hits a lever in the back of your cabinet and that lever pushes your trash holder open. Voila! Like magic! Your door should sit proud of adjacent cabs by 1/4”. Please check your tabs. It looks like you are missing the one on the right. and call your local rev-a-shelf dealer for help. They were very helpful to us when we purchased and installed ours. Good luck!

    My cabinet:


    Looks like more than 1/4”. However, I measured for accuracy.

  • 5 years ago
    last modified: 5 years ago

    Our servo drive was a full set up that included glides. Did you install the entire system or just the servo drive motor? The installation is tricky. Does your glide system look like this?


Sponsored
Custom Home Works
Average rating: 4.6 out of 5 stars10 Reviews
Franklin County's Award-Winning Design, Build and Remodeling Expert