Software
Houzz Logo Print
webuser_471267438

Wiring in double brick wall

4 years ago
last modified: 4 years ago

Hi,

I own a double brick house in Arizona which was built in the 1960's and I want to drill a hole through the exterior wall to install a phone extension without hitting the existing AC wiring. Unfortunately I've been unable to find any information on how this wiring was installed originally. When I removed the plate on an outlet, I could see a small amount of Romex exiting the box vertically at the bottom. Does anyone know the standard routing for these wires (if there is a standard routing), if they run horizontally just below the boxes, between the double brick or in grooves, etc.?

Thanks.

Comments (4)

  • 4 years ago

    There is no "standard." It's whatever the electrician did to accomplish the most efficient wiring runs, which would typically mean fairly direct horizontal runs between receptacles. I think the risk of hitting wiring is minimal, especially if you are drilling the wall close to the floor. If you are really nervous, you just need to be smart about drilling. You should know what the depth of the brick is and you can put a piece of masking tape on the masonry bit equivalent to this dimension. That way you can ease up as you are getting close to breaking through so you don't shove the bit tip way into the cavity when you do break through. Once you have that hole drilled, you can use a small dowel of a piece of wire to probe to confirm there is nothing that feels like wire in the way of the hole; then finish the job. Additionally, you can also buy yourself a cheap boroscope on Amazon; they start at about $40. These are mini cameras on the end of a cable which you can slip into a small hole and get a video of what is inside.

  • 4 years ago
    last modified: 4 years ago

    OK kudzu9, thanks.

    The outlets are only about a foot from the floor and I would like the phone jack near the baseboards so I'll drill as low as possible and be extra careful. Hopefully the electrician who wired these started the horizontal run as soon as the wire exited the bottom of the box which would leave me about a 9" margin to play with.

    Thanks again.

  • 4 years ago

    Watch out for the refrigerant lines. I remember watching a cable TV installer drill through my a/c lines.


  • 4 years ago
    last modified: 4 years ago

    Hi Ron,

    I appreciate the advice, but this house has swamp box (evaporative) coolers, so no refrigerant lines here - at least outside of the refrigerator ;-)

    Thanks.

Sponsored
Kuhns Contracting, Inc.
Average rating: 5 out of 5 stars26 Reviews
Central Ohio's Trusted Home Remodeler Specializing in Kitchens & Baths