Software
Houzz Logo Print
lawrence_palmer

downspout termination question

3 years ago

We're about 97% finished with a new house, but Ihave a question about how the downspouts are tied into the dry wells. The downspouts are 3" round (not rectangular) and were installed by a gutter company, and the dry well connection is 4" round flexible pipe installed by a landscaping company, and there's a lot of room open around the sides of the 3" pipe, and I'm afraid dirt/sand/animals will get in and clog it, but I can't find any kind of standard termination. Does anyone know how this should be done? None of the contractors, oddly enough, seem to know (or care).


Thanks!



Comments (6)

  • 3 years ago

    thank you- i did google it, although I searched for 3" to 4" "downspout" which I guess limited the results too much. A lot of them are listed as "reducers", where in this case it's the opposite (going from small to large), not sure if that matters from the point of which end of the adapter goes inside or outside the pipe it's connecting to, or if you can make a good seal to that flexible ridged pipe coming out of the ground. Sadly, I have no expertise in this area.

  • 3 years ago

    My house was built in 2001 and I have exactly the same situation with my downspouts. I never thought or did anything about it, and I have never had any problems. Bear in mind that if you use an adapter on your downspouts: 1) you will have to disconnect each one to install the adapter, and 2) some of the downspouts may end up slightly crooked if they do not now perfectly align with the center of the 4" in-ground pipe. To me, it's not a problem worth trying to fix.

  • 3 years ago

    Stax-

    1. How do you get an adapter on if the downspout extends into the drain pipe without doing some temporary disconnection?

    2. The offset adapter will solve some alignment problems, but also sometimes results in having to make adjustments to the straps and the amount of offset from the house. I'm not saying they're a bad idea...just questioning whether any adapter is worth the bother.

  • PRO
    3 years ago

    This is a cheap drain system and hopefully, the is no traffic will cross over it. For a regular storm drain, we use schedule 20 sewer pipe, if there are traffic crosses over we use SDR35 pipe.

    Also, for the house connection where the gutter meets the drain, we use a 45 Way fitting for cleanout.

    These corrugated pipes always fail at connections due to settlements, etc and they get clogged up.

  • 3 years ago

    The corrugations on horizontal pipe will be collecting shingle granules, seeds, and debris coming from inside the downspout over time anyway, so worrying about the gap at the downspout transition is moot, but may be an aesthetic issue for you. In the future when the corrugated starts clogging and getting roots into it, you or the new owner can dig it all up and replace with the much better smooth-wall PVC/poly pipe, and have nice tight connections to a downspout adapter (unlike connections on corrugated).