Software
Houzz Logo Print
greenhouser

Weston Mill Questions

18 years ago

I know many of you use the Weston Food Mill. I have one also, with the tomato screen that comes standard with it. There are several questions I have to ask:

1. Although there is washer at the crank, the tomato juice still leaks through where the crank handle goes in, making a small puddle around the stand.

2. The large thin strainer washer ended up around the screw after doing a large pile of tomatoes. What happened?

3. The tomatoes are turned into tomato juice, very watery. I did run the scuzz through several times to get every bit of tomato from the skins and seeds. It's been boiling down now for well over an hour and is still like juice, not sauce. How may hours are you boiling the juice down before it gets thick? I added tomato paste and the toms used were 90% Romas.

4. When the juice comes through the strainer it hits the guard at the top and flies across the table making a real mess. How are you getting around this "shooting" juice? It's like the guard top acts like a "shooter" directing the juice shooting through the strainer. This only happens when the juice itself "shoots" upward.

Thanks... it does do an excellent job of removing the seeds and skins.

Comments (4)

  • 18 years ago

    Rubber O ring seal on cranking shaft is INSIDE the shaft hole, near where the crank is inserted. I do not hve any leaks there at all. The TWIST ON strainers have a rubber washer that acts to help seal any liqids from getting loose before they get pushed into the strainer. The strainer screens are TWIST ON, and use a small single screw to hold them from being twisted off. If that small screw is not tightened or the sieve is not screwed on enough, they can come apart. There is also a spring on the shaft behind the auger. There is a spatter shield that wraps 3/4 the way around the strainers. Depending on tomato types, some contain a LOT MORE water than others. I cut the tomatoes in halves like I have mentioned before. Then, I dig out most of the liquid and some seeds. Then they go through the machine . It may be that 'made in China' means a knock off. Many fake things come from there every day.

  • 18 years ago

    Cranking more slowly eliminates the squirting. Pre softening/cooking the tomatoes also eliminates the problem. Used fresh, even if quartered will result in some squirting. I just lay down some newspaper.

    The leak around the handle shouldn't be there or should only be the occasional drip due to back pressure. It usually means I didn't get the screen and its gasket twisted on all the way and tightened down. The gasket must be inserted behind the screw so it lays flat against the base of the screen. No way it can get twisted in the screw if inserted correctly. Sometimes pre-soaking the gasket in a cup of hot water before using it softens it up and makes the seal better.

    How watery the juice is all depends on the tomatoes used. It has nothing to do with the strainer itself. Cooking down to sauce level normally requires several hours - 4-6 average for me at a slow boil - under any circumstances. Depends on how thick you want it and how high you set the stove temp but 1 hour is nothing when it comes to making sauce. And of course it must be cooked uncovered.

    Dave

  • 18 years ago

    Thanks guys. I may not have had the screen screwed on all the way or tight enough. I let my husband put it back together this time. :) The toms were cooked down quite a bit, the skins were already falling off. I'll cover the table with newspapers the next time I use it to catch any "squirts". I think I'll also quarter the toms instead of halving them. Less chance of squirting I think.

    Ken: I can see the washer in the crank thing, that's why we were surprised it was leaking. It didn't leak the first time it was used. I'm glad I had it set in one of those large cheap tin oven liners. It caught the juice that was leaking out. Where is "Made In Italy" stamped on yours? The only stamp I see says "Roma" on the side and a sticker on the bottom, on the suction cup, says "Made In China." So I don't know if the suction thing is made in China or the whole unit but it is well made.

  • 18 years ago

    I don't cook down any tomatoes. They simply get sorted, bad spots removed and rinsed off. If bigger than the hopper opening, I cut them in halves and scoop out some of the liquid and seeds. It gives a thicker, less watery sauce once strained. I start out using ONLY plum and paste type tomatoes. If I wanted watery sauce I use regular round type 'eating' tomato. About the ony big round ones I use are the oxhearts which are very meaty with little liquid. No liquid leaks out my cranking end on the shaft ever. The shaft is almost fixed in place and is held in by a small E ring on the inside of the housing, and very small (almost clear color) rubber O ring thats in a small groove on the shaft near the cranking end and is up inside against the housing and crank shaft opening.

    Mine has no 'suction thing'. Mine clamps to the edge of a table top and is screwed on from underneath. I bought mine several years ago when its name was Villawere, 'Made in Italy' molded in the aluminium casting. The clamp is also shown in one of my photos as you see below. MIne is EXACTLY as pictured..

    They also show a FULL hopper of tomato 'PIECES'. I don't fill mine THAT full as it would shoot tomato juice up to the ceiling!!

    {{gwi:875174}}