Craftsman Garage Door Keyles entry

19 years ago

I have a Craftsman 1/2 horse GDO model 41A4315-7D and a Keyless entry keypad model 31D302A. I am trying to change the code but am unable to. The keypad only has numbers 0-9 and no ENTER button, so I can't push the button on the opener and walk to the keypad, enter the new 4 digit code and push enter, because there is no ENTER button. I have the code from the previous owners but would like to change it to my own code. Any ideas?

- Fourfingers

Sort by:Oldest

Comments (5)

don_1_2006
19 years ago
Does this keypad have wires?
fourfingers
Original Author
19 years ago
Yes, it has wires that go through the wall and plug into a wall mounted push button door opener. I took a small plate off the front and it has a 9 volt battery and a switch that says PROGRAM and OPERATE. Would I have to switch this to the PROGRAM mode to change the code?
Related Professionals
Austin Accessory Dwelling Units · Gloucester Accessory Dwelling Units · New York City Accessory Dwelling Units · Kenosha Accessory Dwelling Units · Chico Accessory Dwelling Units · Santa Fe Accessory Dwelling Units · St. Louis Home Additions · San Diego Home Additions · Pueblo Home Additions · Selma Carpenters · Jonesboro Carpenters · Clarksburg Carpenters · Rochester Carpenters · Watertown Carpenters · Coeur d'Alene Carpenters
don_1_2006
19 years ago
Good here we go. To program the keypad, first unplug the garage door opener from the electrical outlet. Flip the operate/program switch to program. Next, enter your desired four digit PIN number into the keypad. Slide the switch back to operate and plug the garage door opener back in. The keypad should be programmed.
fourfingers
Original Author
19 years ago
Yes, it worked beautifully !!
Thanks !!
dastrayer_yahoo_com
15 years ago
Worked for me too. Thanks much