OPENING THE GLASS DOOR

To open the glass door on an ASKO washer, the power must be on and you must press the Door Open button.

There will be a few seconds delay before the door opens.

W600 and W620: On these models the Program Control knob must be at the end of a program (at the 12:00 or zero position) to open the glass door.

If you need to stop or interrupt a program after you start the machine, turn the Program Control knob to 10 (Drain).

Any water in the machine will be pumped out and you can then press the Door Open button to open the door.

To restart the washer, close the door and turn the controls to the desired settings.

If there is no water in the machine and the door wonÂt open in the normal manner,
you should be able to open it manually, as follows:

a. Make sure the power is turned off.

b. Using a flathead screwdriver, gently pry open the drain pump cover.

c. Empty out any water that may be in the machine by disconnecting the drain hose from the door pin.

IMPORTANT If there is still water in the drum, make sure you have a large container ready to catch the water.

d. Unscrew the emergency door opener handle and pull it out to open the door.

e. Replace the emergency door opener handle.