Software
Houzz Logo Print
dave10_gw

Air Conditioning Energy Saver Switch

18 years ago

I'm getting killed on my electric bills at my office. The 220V AC units are always being left on. Is their a device that I can install with a key that will stay locked in the cylinder in the on position (to activate the AC) and release in the off position. It will be the same key for the front door so that when people leave for the day, they will have to remove the key - AC goes off - in order to lock the front door???

Any help/ideas greatly appreciated

Comments (10)

  • 18 years ago

    Might be able to use one of these, hooked to a relay , if you want to shut the unit completely off

    Here is a link that might be useful: Keyswitches

  • 18 years ago

    You probably can find that kind of switch from an industrial distributer, but you won't find one that takes the same key blank as the front door. Maybe you could put the two keys on a ring that is welded shut.

  • 18 years ago

    Timers are more readily available.

  • 18 years ago

    There is an effective non-electrical solution, assuming that you are either the business owner or supervisor. The next time that you come in and find the A/C left on shut it off for the entire following workday. You will probably not have to do this more than twice for the message to get across.

    If you still want a switched solution, a 7 day timer might work well to limit A/C use to specific hours only. Put it in a secure enclosure or it will be quickly defeated by rebellious employees.

  • 18 years ago

    wayne440 has the right idea.

    Or, to go even further, sit down your employees and explain how if they can't do such a simple task that is part of their job, they will have to find a new job.

    Your idea of using a front door key that has to be removed by shutting off the AC is smart, but it seems more like a Bandaid. What you need is competent employees.

  • 18 years ago

    Just an odd memory from my past that this thread brought up. I was like 14 and put an alarm in my garage. I didn't have an actual keyswitch so I made one using a deadbolt and a microswitch I scavenged out of a microwave oven. When you locked the deadbolt, its ... well, "bolt", pressed the microswitch and armed the alarm. Voila, electrical keyswitch using the "front door" key - a LOT more secure than the snowmobile ignition keyswitch it replaced, since this certain snowmobile manufacturer only makes five different keys, which can be ordered by telephone no-questions-asked. :)

    low-voltage and relays, anyone? :)

  • 18 years ago

    I don't know what kind of dollars we're talking about here, but the "conventional" solution to this problem is to install a Building Management System that uses occupancy sensors, clocks, and a calendar to control both the HVAC and the lighting to minimize energy use.

  • 18 years ago

    Also consider other ways to economize. Night-time operation may be the smaller part of your electric bill. Is there any place insulation should be improved? Is there adequate air circulation? People can be comfortable with the air several degrees warmer if it is moving.

  • 18 years ago

    Billhart-
    The keyswitch detailed above uses any standard mortise cylinder, as is listed in the data sheets-
    "MK series
    Cylinder: Accepts any U.S> 1-1/8" or 1-1/4"
    mortise cylinder with any cam."
    We use them all the time and have them keyed to a building key.

  • 18 years ago

    You could simply install a timeclock to break the thermostat wire that controls the cooling.
    Set it to shutoff at quitting time and turn it back on 1/2 hour before the office opens.
    If you use a seven day timeclock, it could be set so that the AC doesn't run on the weekends or for a minimal amount of time.