Doubtful.

Thanks Joseph. The wall is a little off center from the house and it looks like it's just sitting on the floor joists without any support down to the foundation. Also, wouldn't there be some type of brace, like a 2x4 top plate, that would run across all the trusses, instead of the individual 2x4s coming down vertically from each truss?

It doesn't look like it would be load bearing, especially if that is the framing below it. The truss design looks to be made to do a full span but we always send them in to our structural engineer we use to make sure. They generally will do a simple review for under $200.00. Without the full specs that came with the trusses it is just an educated guess. We always tell our clients it is better to be safe then sorry.

The lightweight steel studs are incapable of carrying loads. Scissors trusses are self-supporting.

Casey