Software
Houzz Logo Print
tdfurlong

Blum overlay compact soft close hinges - cabinet not level

9 years ago
last modified: 9 years ago

We are finishing up a kitchen remodel. Our cabinets have Blum 1-1/4" Compact Overlay soft close cabinet hinges. You can loosen one set of screws to adjust the cabinets up/down. Then there are 2 more adjustment screws (to move the cabinet in/out and left/right).

The problem is that we have pantry cabinet doors that we can get adjusted because they don't appear to be "level". We need to adjust a corner of the cabinet up or down to have it inline. Does this mean the hinge was put on slightly crooked? How can we fix this? It's driving me nuts!!

The picture is as good as we can get it. You can see on the doors on the right, on the top door the lower right side should be adjusted slightly down (or on the bottom door the right upper corner should be slightly adjusted up). Additionally, on the left lower door, it pops out just slightly past the bottom right door. The door is adjusted "in" as much as it can be adjusted. If we adjust the right lower door "out", that doesn't seem to fix it either. I can live easier with that, though I still don't like it.

Comments (9)

  • 9 years ago

    Is this pantry door screwing into a cabinet or into a wall? One of our pantries has doors the mount to the wall, and no amount of adjusting will ever make them level to the wall, because the wall is bowed.

  • PRO
    9 years ago

    Your cabinet is probably "racked" or being pulled out of square, and subsequently the front out of plane, by improper installation. Put at least a 4' level on the front and sides and get back to us, please.

  • 9 years ago

    Held level up to side of cabinet and opened cabinet doors and placed level along the front. Both show as level. Attaching pictures to be sure I was holding the level where you meant.



  • PRO
    9 years ago

    How long is the level, please?


  • 9 years ago
    last modified: 9 years ago

    The longest I have - which is 24". I have 2 of those that length. I will say that prior to the countertops being installed, we used the contractor's long level (a long one that spanned several cabinets) - and we checked out the leveling of the base cabinets. They were spot on, side to side, front to back, wherever we laid the level. I will say that is the one thing he seemed to do well. I was thinking about contacting Kraftmaid, as we had this issue with the pull out trash. A Kraftmaid rep happened to be at our house for something else - and the rep fixed the pull out trash as we told him our contractor said he had done everything he could to get it level (one side was not level). The rep fixed it. I don't know exactly what he did to fix it though, I was speaking with the other person there with him about the issue they were there about.

  • PRO
    9 years ago

    A 2'er can't tell you much. Rent a 6' if you have to please.

  • PRO
    9 years ago

    You check a door for square by measuring the corners diagonally. If the measurements are equal, the door is square. Place a 4' straightedge over the door in an "x" fashion as well as on the stiles to check the door for flatness.

  • 9 years ago
    I discovered that at least part of the problem is the top hinge on the left base door. The hinge in the front does not sit flush against the cabinet face. That would be why that door pops out past the right door. I ultimately contacted Kraftmaid and they will be coming out to fix. I sent a picture, I think the hinges may not be set right either. Will update after they visit.