Software
Houzz Logo Print
kudzu9

Adding LED bulbs to an existing low voltage system

6 years ago

I have an outdoor lighting system running off a 15-year-old, 12 volt Malibu brand transformer. The system consists of four lighting fixtures that have standard 5 watt halide bi-pin bulbs. I just bought two old Japanese lanterns that I want to wire up with LED bulbs, hang outside, and add to the system. When I was at the hardware store buying parts, the clerk mentioned that there could be problems adding LED bulbs to the system as I might not have an "LED-compatible" transformer. However, he couldn't explain to me exactly why this would be a problem. Any insights would be appreciated....

Comments (6)

  • 6 years ago

    Bare LED bulbs require DC. I purchased a few "strips" which consist of several LED chips wired together and they say they require DC, either 12 or 24 volts. I purchased 12 and 24 volt DC power supplies (magnetic) from Jameco and they work fine using dimmers. I don't like "electronic transformers" because they can create electrical noise.

  • 6 years ago

    mtvhike- Yes, I know that the lights require 12 volt DC, which is what my transformer provides. The question is simply whether there are any electrical incompatibilities by having both halide and LED bulbs running off the same, older transformer. I have adequate excess transformer capability to handle the few extra watts the two extra LED bulbs would require; I just want to ensure there aren’t any electrical issues I’m not aware of.

  • 6 years ago
    • Yes, I know that the lights require 12 volt DC, which is what my transformer provides.

    Are you sure that your transformer is not AC?

  • 6 years ago
    last modified: 6 years ago

    dennisgli-

    Yes, good catch. It’s just a standard, garden variety, landscape transformer with 12 volt AC output. Now that that’s clarified, do you have any insight on my original question? I intend to use bi-pin LED bulbs in the appropriate porcelain sockets, and the bulbs would be the standard type that you can replace halide bulbs with in a low voltage system. The issue is whether it’s ok to use both halide and LED bulbs on the same wiring run :-)

  • 6 years ago

    No, you can not run LED's with the Halide bulbs. There is no regulation of current for the LED's and they would burn out in a nanosecond. On that note you can use a 12VAC source to operate a LED with a constant current circuit without a driver. You can use a simple current limiting resistor in series with two LED's in parallel with the anodes (+) and cathodes (-) opposite of each other but it will flicker.

    I have in my hand an outdoor transformer for a LED system with a 12VAC output, but inside is a constant current limiting circuit to make the LED's work. Each fixture has 4 LED's in them as I described above and very dim. It was expensive over a decade ago and primitive by today's standards.

    You can build a simple circuit for each fixture to accept an LED with a bridge rectifier and a power resister using one LED if you wish. You will need to know the Forward voltage and current of the LED to rectify the AC to DC and select the right resistor to limit the current and install the LED in the right polarity, or buy a new LED system and just reuse the wiring from the old system.

  • 5 years ago

    My kitchen track lighting has a mix of halogen and LED lights. The tracks are on two big 12 Volt transformers.

Sponsored
Bella Casa LLC
Average rating: 5 out of 5 stars17 Reviews
The Leading Interior Design Studio in Franklin County