how do i straighten/re-program a hose?

5 years ago

Howdy!

I think it is rubber - in better light, it is reddish. It has lasted many years, in full sun, on a reel. So, I guess I do appreciate it. (And actually, the reel it has been on has lasted too - except, the little connector hose leaked so badly I finally disconnected it ... the mfr is behind in production bc of covid ... could I get a generic replacement, I wonder?)

Anyhow, so, I took the hose off the reel because it is semi-drought here and it was spraying water all over.

As you might imagine, it was all coiled and bent when I took it off. (It also has a couple spots where it kinks.)

I stretched it all out and I thought I could leave it out in the sun for a couple hours tomorrow - is that a good idea or a bad idea? I just want it to relax and be a regular, non-reel hose again.

There are a couple spots where it doesn't lie flat. I fiddled with it but could not solve the problem.

I ask because I feel like there is a right way and a wrong way to deal with hoses, and I'm never quite sure I am doing it right.

Anyhow, tomorrow I'll just put it into a normal little circle on the ground ... while I research looking for a generic smaller hose/leader hose?/connector hose for the reel.

What do other people do about such problems?

Featured Answer

ci_lantro

5 years ago

I had never heard of reprograming a garden hose until yesterday when I was shopping for new hoses on Amazon.

In one of the user reviews, a guy was talking about this and how he has done it for years. He starts out by doing what you've done--stretching the hose out straight in the sun. Attaches a hose sprayer on the end. Fills with water and lets the air out of the hose using the sprayer. Object is to have the hose completely full of water. Then he leaves the water on at the faucet, with the tap on about 1/4 to keep it under pressure. (I would use my judgement on this because 1/4 on would probably be too much with my water pressure.) I don't remember how long he leaves it like this but it was several hours. Sorry, but I looked at too many different hoses when shopping for it to be easy to go back and find that review again. I did not decide on which hose to buy so if I come across the review again, will cut & paste it here.

And, obviously, proceed at your own risk.

Sort by:Oldest

Comments (7)

Need2SeeGreen 10 (SoCal)
Original Author
5 years ago
Wow, ci_lantro, thanks! I will go look for that - maybe a google site search will work.

The part that is frustrating is - and perhaps I had the wrong expectations - I feel like I shouldn't be getting outwitted by a rubber hose. When I used to put it back on the reel, I would first rotate the length closest to the reel, to try to get it to lie flat (when necessary). I figured, if it lay flat that meant something good. (No real idea if that's true...) But, always there are a couple parts where I juuuust can't get it to be flat.

Why?

Maybe it shouldn't matter so much. Hose still works - it's the other things that are breaking.

Still, thank you again !! At least I know I'm not the only one...
Related Professionals
Florence Landscape Architects & Landscape Designers · Ontario Landscape Architects & Landscape Designers · Greenville Landscape Contractors · Oshkosh Landscape Contractors · Mission Viejo Landscape Contractors · Terre Haute Tile and Stone Contractors · Vicksburg Tile and Stone Contractors · Petersburg Tile and Stone Contractors · Dothan Home Remodeling · Little Rock Home Remodeling · Mansfield Home Remodeling · Sacramento Home Remodeling · Terre Haute General Contractors · Kingman General Contractors · Philadelphia Bathroom Remodelers
ci_lantro
5 years ago
Found it:

I still ordered this hose even after reading all the bad reviews. Why? ‘Treating’ the hose is all it takes so the hose will not kink. And for those hoses coming in already kinked? Just treat the hose and here is how to do it. First and foremost, it must be a very warm day out and sun shinning. Hook the hose to your outlet. Make sure you have plier or channel lock and use it to tighten the fitting but not so tight as to tear the rubber grommet. Stretch the hose out until it is fully extended on the ground in as much sunlight as you can get. Put on your spray nozzle last. As you stretch the hose out, the air inside needs a way to escape. Turn the water on. Allow it to flow till you have a good spray and all air is out. Stop water from coming out of nozzle, turn off water then turn back on 1/4 turn and set hose down and walk away from it for the better part of the day. The warm to hot air and the sun will heat the water up. In turn this will soften the hose. Spray water out, wind hose up normally and by the next day, the hose will be tighten back up minus the kinks and also will not allow hose to kink while in use. I have always done this method since shown by a friend and it works amazingly!

Let me know if it works!
Need2SeeGreen 10 (SoCal) thanked ci_lantro
cat_ky
5 years ago
Hoses have a certain amount of time, before they need to be replaced. I replaced my rubber hoses this year. They are many years old. Actually, they are still sitting in the hose reel, because, I am trying some that are very light weight, and much easier for me to handle. I know these new ones wont last as long as my older ones, but, I will live with that part, to have a nice light weight hose.
toxcrusadr
5 years ago
Older hoses do start to lose their elasticity and may not return to straight even if left in the sun. They're kind of like skin: the older they get, the more wrinkles show up that just won't go away.

You only have to leave the faucet barely cracked open to maintain pressure. And that's only if the hose leaks, but they almost always leak SOMEwhere, even if only a little. A perfect system would maintain pressure indefinitely with the faucet off, after it was pressurized.
Need2SeeGreen 10 (SoCal)
Original Author
5 years ago
Thanks for all the comments! I will see if I can figure out ahead of time which little hose might fit on the reel. I hate to be a pessimist but I doubt I am strong enough even to remove the old one - I will have to find help. But, it would be nice to get the reel working again - it keeps the hose off the hot concrete, and I do think it looks nicer too.

I confess, I chickened out and just coiled the hose up again. Although not perfectly straight, it was good enough, I decided. It just seemed risky to leave it out on concrete in this hot sun. I will just consider the wrestling part to be exercise.

Thanks again!!
krissie55
5 years ago
A new hose reel shoud not be too expenisve.