Software
Houzz Logo Print
zumtobel

Inside corner trim where stainless steel meets up

last year


Where the sides of my stainless steel wall shield meet up under my range hood, I am looking for something much better than the white polywall FRP inside corner trim I have in place. If it all butted up squarely, I wouldn't have the problem. But it doesn't, there is about a 1/4 inch gap where it meets up. I have done a lot of searches online but no luck so far. Any ideas?

Comments (6)

Sponsored
Hope Restoration & General Contracting
Average rating: 4.7 out of 5 stars35 Reviews
Columbus Design-Build, Kitchen & Bath Remodeling, Historic Renovations