FULL HOUSE REMODEL – COMPLETE SCOPE OF WORK 1. Pre-Construction Phase • Initial site inspection and measurements • Architectural design and layout planning (if required) • Structural engineering (if load-bearing walls are modified) • Preparation of plans for city approval • Permit application and plan check • Obtain required building permits • Scheduling of inspections • Homeowner responsible for permit fees unless otherwise stated. 2. Site Preparation & Protection • Protect flooring and non-work areas • Install plastic dust barriers with zipper access • Cover windows and furniture as needed • Temporary utility setup if required • Daily job site cleanup • Final professional cleaning upon completion 3. Demolition • Remove existing flooring (tile, wood, carpet, etc.) • Remove cabinets, countertops, vanities • Remove interior walls per plans • Remove drywall where required • Remove plumbing fixtures • Remove electrical fixtures • Haul away all debris 4. Structural & Framing • Install structural beams if required • Reframe modified walls • Install new partitions per approved plans • Repair or replace damaged framing • Subfloor repair or replacement as needed • Install blocking for cabinets and accessories 5. Plumbing (Up to Code) • Replace old water supply lines (Copper Type L or PEX) • Replace or modify drain lines (ABS) • Relocate plumbing fixtures as needed • Install new shut-off valves and cleanouts • Water heater replacement if included • Call for rough and final plumbing inspections 6. Electrical (Up to Code) • Upgrade electrical panel if required • Rewire entire house as needed • Install new outlets and switches • Install GFCI/AFCI protection per code • Install recessed lighting and fixtures • Install smoke and carbon monoxide detectors • Dedicated circuits for appliances • Call for rough and final electrical inspections 7. HVAC • Replace or upgrade HVAC system if included • Install new ducting and registers • Install thermostat or mini-split system if applicable 8. Insulation • Install wall insulation per code requirements • Install ceiling insulation per code requirements 9. Drywall & Plaster • Install new drywall • Tape and mud (Level 4 or 5 finish) • Texture to match existing or smooth finish • Patch all affected areas 10. Flooring • Install tile flooring • Install engineered wood / hardwood / laminate / vinyl • Install baseboards • Floor leveling if required 11. Kitchen Remodel • Install new cabinets • Install countertops • Install backsplash • Install sink and faucet • Install appliances (owner supplied unless specified) 12. Bathroom Remodel(s) • Install new tub or shower system • Waterproofing system installation • Install tile on floors and walls • Install vanity and toilet • Install shower valve and fixtures • Install shower glass if included 13. Doors & Windows • Replace interior and entry doors • Replace windows if included • Install hardware 14. Interior & Exterior Paint • Surface preparation • Prime and paint walls, ceilings, and trim • Exterior painting if included 15. Exterior Work (If Included) • Stucco repair • Roofing repair or replacement • Concrete work or pavers • Drainage improvements 16. Final Phase • Final inspections • Punch list completion • Final cleaning • Final walk-through with homeowner Standard California Contract Terms (Summary) • All work performed in compliance with California Building Code. • Change orders must be approved in writing. • Unforeseen conditions may require additional cost. • One-year labor warranty unless otherwise stated. • Progress payments per agreed payment schedule. • Contractor is licensed and insured.